The Connection between Biaxial Orientation and Shear Thinning for Quasi-Ideal Rods
نویسندگان
چکیده
The complete orientational ordering tensor of quasi-ideal colloidal rods is obtained as a function of shear rate by performing rheo-SANS (rheology with small angle neutron scattering) measurements on isotropic fd-virus suspensions in the two relevant scattering planes, the flow-gradient (1-2) and the flow-vorticity (1-3) plane. Microscopic ordering can be identified as the origin of the observed shear thinning. A qualitative description of the rheological response by Smoluchowski, as well as Doi–Edwards–Kuzuu theory is possible, as we obtain a master curve for different concentrations, scaling the shear rate with the apparent collective rotational diffusion coefficient. However, the observation suggests that the interdependence of ordering and shear thinning at small shear rates is stronger than predicted. The extracted zero-shear viscosity matches the concentration dependence of the self-diffusion of rods in semi-dilute solutions, while the director tilts close towards the flow direction already at very low shear rates. In contrast, we observe a smaller dependence on the shear rate in the overall ordering at high shear rates, as well as an ever-increasing biaxiality.
منابع مشابه
Biaxial shear of confined colloidal hard spheres: the structure and rheology of the vorticity-aligned string phase.
Using a novel biaxial confocal rheoscope, we investigate the flow of the shear induced vorticity aligned string phase [X. Cheng et al., Proc. Natl. Acad. Sci. U. S. A., 2011, 109, 63], which has a highly anisotropic microstructure. Using biaxial shear protocols we show that we have excellent control of the string phase anisotropic morphology. We choose a shear protocol that drives the system in...
متن کاملPREDICTING THE STIFFNESS OF BIAXIAL BRAIDED FIBER COMPOSITES BY INCORPORATION OF CARBON NANO FIBER
In this study, carbon nano fibers (CNFs) were mixed into epoxy resin through a magnetic stirrer and again mixed using ultra sonicator. Using hand layup technique, biaxial braided fiber composites were prepared with unfilled, 0.2, 0.5 and 1 wt% CNF. Tensile test and shear test was performed to identify the tensile strength and shear strength of the composites. Fractured surface of the tensile sp...
متن کاملModeling the Rheology and Orientation Distribution of Short Glass Fibers Suspended in Polymeric Fluids: Simple Shear Flow
In this paper we present a constitutive relation for predicting the rheology of short glass fibers suspended in a polymeric matrix. The performance of the model is assessed through its ability to predict the steady-state and transient shear rheology as well as qualitatively predict the fiber orientation distribution of a short glass fiber (0.5 mm, L/D < 30) filled polypropylene. In this approac...
متن کاملConnections between C(X) and C(Y), where Y is a subspace of X
In this paper, we introduce a method by which we can find a close connection between the set of prime $z$-ideals of $C(X)$ and the same of $C(Y)$, for some special subset $Y$ of $X$. For instance, if $Y=Coz(f)$ for some $fin C(X)$, then there exists a one-to-one correspondence between the set of prime $z$-ideals of $C(Y)$ and the set of prime $z$-ideals of $C(X)$ not containing $f$. Moreover, c...
متن کاملEvaluation of the Effect of Connection between RC Shear Wall and Steel Moment Frame on Seismic Performance and Reduction Factor in Dual Systems
Dual systems of steel moment frame and reinforced concrete shear wall have combined the advantages of steel frames and reinforced concrete shear wall. These walls have increased the lateral stiffness of steel frames and have reduced seismic demands on steel frames thus providing opportunities to use such system. In this research intermediate dual system of steel moment frame was chosen with int...
متن کامل