A variable gain wideband CMOS low-noise amplifier for 75 MHz-3 GHz wireless receivers
نویسندگان
چکیده
A wideband CMOS variable gain low noise amplifier suitable for multi-standard radio applications between 75 MHz and 3 GHz is presented. Wideband matching to 50 Ohm (single ended) is achieved using a common-drain feedback stage whereas variable gain is realized using a resistive attenuator. The circuit has been designed in a 65 nm CMOS process and achieves 22 dB maximum gain, 29 dB gain range, 3.3 dB noise figure, and an IIP3 higher than -4 dBm.
منابع مشابه
A Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملA 3-6 GHz Current Reused Noise Canceling Low Noise Amplifier for WLAN and WPAN Applications
ISSN: 2347-8578 www.ijcstjournal.org Page 315 A 3-6 Ghz Current Reuse Noise Cancelling Low Noise Amplifier For WLAN And WPAN Application Shivabhakt Mhalasakant Hanamant [1], Dr.S.D.Shirbahadurakar [2] M.E Student , Guide [2] Department of E & TC Dr. D.Y.Patil COE, Ambi Pune – India ABSTRACT A wideband low-noise amplifier (LNA), which is a key block in the design of broadband receivers for multi...
متن کاملA 22–29-GHz UWB Pulse-Radar Receiver Front-End in 0.18- m CMOS
The design of a CMOS 22–29-GHz pulse-radar receiver (RX) front-end for ultra-wideband automotive radar sensors is presented. The chip includes a low-noise amplifier, in-phase/quadrature mixers, a quadrature voltage-controlled oscillator (QVCO), pulse formers, and baseband variable-gain amplifiers. Fabricated in a 0.18m CMOS process, the RX front-end chip occupies a die area of 3 mm . On-wafer m...
متن کامل