Procedure for LEED I-V structural analysis of metal oxide surfaces: Ca1.5Sr0.5RuO4„001..
نویسندگان
چکیده
V. B. Nascimento,1,2,* R. G. Moore,1,2 J. Rundgren,3 Jiandi Zhang,2,4 Lei Cai,4 R. Jin,2 D. G. Mandrus,1,2 and E. W. Plummer1,2,5 1Department of Physics and Astronomy, The University of Tennessee, Knoxville, Tennessee 37996-1200, USA 2Materials Science and Technology Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831, USA 3Department of Theoretical Physics, Alba Nova Research Center, Royal Institute of Technology (KTH), SE-106 91 Stockholm, Sweden 4Department of Physics, Florida International University, Miami, Florida 33199, USA 5Center for Nanophase Materials Sciences, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831, USA Received 17 October 2006; published 11 January 2007
منابع مشابه
Structure and Energetics of P-rich GaP(001) Surfaces
The microscopic structure of the GaP(001) surface is not well understood, in marked contrast to other III–V compounds, in particular GaAs(001) (see Ref. [1] for a recent review). It has been suggested that ion bombardment and annealing of GaP(001) results in a (4 2) reconstructed Ga-rich surface [2, 3] in analogy to GaAs. On the other hand, based on ion scattering spectroscopy and low-energy el...
متن کاملمطالعه سطح Ni(001) با استفاده از محاسبه منحنی های I/E در روش (LEED)
The rcnccted beam intensity as a lunctlon of dcclron energy ( lIE curve) is studied for an ideal (001) Ni surface by low energy electron diffraction (LEED). Double layer method, rcnormalized forward scattering (RFS) and quasi-dynamic method arc used for lIE curves calculation. The role of structural and nonstructural parameters of Ni on lIE curves is examined. The crfect or the optical p...
متن کاملChiral surfaces and metal/ceramic heteroepitaxy in the Pt/SrTiO3(621) system
Low-energy electron diffraction (LEED), atomic force microscopy (AFM), and X-ray diffraction (XRD) have been used to investigate the structural and morphological character of a naturally chiral ceramic SrTiO3(621) substrate and of Pt and Cu thin films deposited on its surface. AFM experiments showed that as-received chirally-oriented SrTiO3(621) substrates display atomically smooth surface morp...
متن کاملCharge ordering on the surface of Fe 3 O 4 „ 001 ...
We have studied the ~001! surface of a Fe3O4 single crystal using scanning tunneling microscopy ~STM!, low-energy electron diffraction ~LEED!, and Auger electron spectroscopy. A clean surface was obtained by a combination of Ar ion sputtering, in situ annealing in O2 atmosphere, and further annealing in ultra high vacuum conditions. A sharp (A23A2)R45° reconstruction was observed by LEED and ST...
متن کاملStructural studies of sulfur-passivated GaAs (100) surfaces with LEED and AFM
We present the results of Auger electron spectroscopy (AES), low-energy electron diffraction (LEED) and atomic force microscopy (AFM) analysis of sulfur-passivating layers on the GaAs (100) surface. The GaAs surfaces were passivated with both inorganic 42x and organic [octadecylthiol (ODT)] S-based compounds. We prepared the inorganic sulfur-passivated GaAs(100) surfaces with a wet chemical tre...
متن کامل