The Effect of Surfactant Monolayers on the Heat Transfer Through Air/Water and Oil/Water Interfaces Using IR Imaging Technique.

نویسندگان

  • Fang
  • Shah
چکیده

An experimental investigation on the effect of surfactant monolayers on the heat transfer through air/water and oil/water interfaces was carried out by observing the changes of surface temperature with IR Imaging Radiometer (Model 760). The heat transfer resistance of various single component and mixed monolayers at air/water and oil/water systems was studied. The results show that the surfactant monolayers introduce a noticeable heat transfer resistance to the heat transfer process across the interface. The solid monolayers exhibit lower resistance to heat transfer than the liquid monolayers at the oil/water interface. At air/water interface, the presence of monolayer decreases the evaporative cooling process and therefore increases the surface temperature rapidly. However, the presence of a monolayer at oil/water interface increases the heat transfer resistance across the oil/water interface. Heat transfer resistance increases as the chain length of fatty acid increases at the oil/water interface. The effects of phase-transition from a two-dimensional solid to the liquid state in cholesterol-arachidyl mixed monolayers was observed from the change in heat transfer resistance of the monolayers at the oil/water interface. The optimum molecular packing at the 1:3 molecular ratio in mixed surfactant monolayers of oleic acid-cholesterol and stearic acid-stearyl alcohol at the oil/water interface was also observed by this technique. Copyright 1998 Academic Press.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of nonionic surfactant additives on the performance of nanofluid in the heat exchanger

A nanofluid is mixture of nano sized particles and a base fluid. This paper investigates by using laboratory based double pipe heat exchanger model, the performance of nanofluid containing about 48.46nm  particle size nanoparticles (ZnO) without or with addition of nonionic surfactant Rokanol K7 (500ppm) into the base fluid double distilled water to prepared three different concentrations 1.0%,...

متن کامل

Effect of nonionic surfactant additives on the performance of nanofluid in the heat exchanger

A nanofluid is mixture of nano sized particles and a base fluid. This paper investigates by using laboratory based double pipe heat exchanger model, the performance of nanofluid containing about 48.46nm  particle size nanoparticles (ZnO) without or with addition of nonionic surfactant Rokanol K7 (500ppm) into the base fluid double distilled water to prepared three different concentrations 1.0%,...

متن کامل

Heat transfer enhancement due to air bubble injection into a horizontal double pipe heat exchanger

If an air flow is injected into a liquid fluid, many ambulant air bubbles are formed inside the fluid. Air bubbles move inside the liquid fluid because of the buoyancy force, and the mobility of these air bubbles makes sizable commixture and turbulence inside the fluid. This mechanism was employed to enhance the heat transfer rate of a horizontal double pipe heat exchanger in this paper. Howeve...

متن کامل

Molecular simulations of surface forces and film rupture in oil/water/surfactant systems.

We use dissipative particle dynamics (DPD) and molecular models to simulate interacting oil/water/surfactant interfaces. The system comprises sections of two emulsion droplets separated by a film. The film is in equilibrium with a continuous phase, in analogy with the surface force apparatus. This is achieved by combining DPD with a Monte Carlo scheme to simulate a muVT ensemble. The setup enab...

متن کامل

Water thickness effect on the fin efficiency and heat transfer for partially wet-surface heat exchanger

Heat and mass transfer, in this paper, is considered in one-row heat exchanger, that fins are hotter than air flow and water is added to fins. Related governing equations are derived by analyzing a two-dimension model in a unique cell of a heat exchange. These equations are numerically solved by finite difference method. Heat transfer and efficiency under partially wet surface are calculated by...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of colloid and interface science

دوره 205 2  شماره 

صفحات  -

تاریخ انتشار 1998