Heat Transfer and Microbial Kinetics Modeling to Determine the Location of Microorganisms within Cucumber Fruit
نویسنده
چکیده
Microbiological and modeling (combined heat transfer and microbial kinetic equations [HTMK] model) approaches were used to determine the location of microorganisms within cucumber. The total number of aerobes found within/on cucumbers varied from 10 to 10 colony-forming units (CFU)/g. The highest and the least amount of microbiota were respectively found at the blossom end and middle part of the cucumbers and were within the 1st 6 mm of the cucumber surface. A comparison of the calculated thermal death time from the HTMK model with the values obtained from experimental data showed that total aerobic microorganisms were located within 0.65 mm of the fruit surface.
منابع مشابه
Three-dimensional modeling of transport phenomena in a planar anode-supported solid oxide fuel cell
In this article three dimensional modeling of a planar solid oxide fuel cell (SOFC) was investigated. The main objective was to attain the optimized cell operation. SOFC operation simulation involves a large number of parameters, complicated equations, (mostly partial differential equations), and a sophisticated simulation technique; hence, a finite element method (FEM) multiphysics approach ...
متن کاملA Numerical Modeling for Natural Convection Heat Transfer in Porous Media With Generated Internal Heat Sources
In this paper a numerical method is used to study the unsteady state natural convection heat transfer within a confined porous media with uniform internal heat generation. The governing equations based on the Darcy model and Bossiness approximations are solved, using the finite difference Alternating Direction Implicit (ADI) method. The developed program was used to simulate natural convection ...
متن کاملSOLIDIFICATION MODELING AND DENDRITE STRUCTURE ANALYSIS IN A HORIZONTAL CONTINUOUSLY CAST BRASS BILLET
Abstract: The horizontal continuous casting process has received a significant attention for near net shape casting of non ferrous metals and alloys. Numerical Simulation has been widely used for process design and optimization of continuous casting process. In the present study, a 3-dimensional heat flow model was developed to simulate the heat transfer and solidification in a horizontal b...
متن کاملNonlinear Analysis of Integrated Kinetics and Heat Transfer Models of Slow Pyrolysis of Biomass Particles using Differential Transformation Method
The inherent nonlinearities in the kinetics and heat transfer models of biomass pyrolysis have led to the applications of various numerical methods in solving the nonlinear problems. However, in order to have physical insights into the phenomena and to show the direct relationships between the parameters of the models, analytical solutions are required. In this work, approximate analytical solu...
متن کاملMixed convection fluid flow and heat transfer and optimal distribution of discrete heat sources location in a cavity filled with nanofluid
Mixed convection fluid flow and heat transfer of water-Al2O3 nanofluid inside a lid-driven square cavity has been examined numerically in order to find the optimal distribution of discrete heat sources on the wall of a cavity. The effects of different heat source length, Richardson number and Grashof number on optimal heat source location has been investigated. Moreover, the average Nusselt num...
متن کامل