TEM investigations on growth interrupted samples for the correlation of the dislocation propagation and growth mode variations in AlGaN deposited on SiNx interlayers
نویسندگان
چکیده
Threading dislocations (TDs) can be reduced by in-situ deposition of intermediate SiNx sub-monolayers in group III-nitride heterostructures and their ternary alloys. Here we observe efficient dislocation density decreasing at the SiNx nano-mask in an AlxGa1 xN layer with x1⁄40.2 grown epitaxially on c-plane sapphire by low pressure MOVPE. However we did not achieve high annihilation efficiency grade alternate along the interface in accordance with respective variations in the SiNx distribution. Furthermore an unusual dislocation bundling was observed for the dislocations in areas with high dislocation densities above the SiNx interface, leading to large areas of several mm with low dislocation densities at the surface between the dislocation bundles. By using growth interrupted samples under same growth conditions, it was possible to investigate the heterostructures in different growth stages by cross-sectional TEM. This enabled us to correlate the dislocation propagation with growth mode variations in AlGaN deposited on the SiNx interlayer and to develop a growth model for the AlGaN layer grown on the SiNx nano-mask. & 2011 Elsevier B.V. All rights reserved.
منابع مشابه
In-situ deposited SiNx nanomask for crystal quality improvement in AlGaN
We report the growth of high crystal quality Al0.3Ga0.7N directly on sapphire substrates with metalorganic vapour phase epitaxy. We studied the improvements in crystal quality by introducing an in-situ deposited SiNx interlayer. It acts as a nanomask which results in termination of the dislocations near the interface between the nanomask and epilayer. The epilayers with no SiNx interlayer have ...
متن کاملEfficient 350 nm LEDs on low edge threading dislocation density AlGaN buffer layers
Improving the crystal quality of AlGaN epitaxial layers is essential for the realization of efficient III-nitride-based light emitting diodes (LEDs) with emission wavelengths below 365 nm. Here, we report on two different approaches to improve the material quality of AlGaN buffer layers for such UV-LEDs, which are known to be effective for the MOVPE growth of GaN layers. Firstly, we grew AlGaN ...
متن کاملHigh quality AlGaN epilayers grown on sapphire using SiNx interlayers
We have investigated the optimization of Al0.2Ga0.8N layers directly grown on sapphire by metalorganic vapor phase epitaxy (MOVPE). The quality of the AlGaN epilayers was improved by in situ nano-masking employing ultra-thin SiNx interlayers. Transmission electron microscopy (TEM) investigations reveal an enormous reduction of edge-type dislocations by SiNx nano-masking. Furthermore, formation ...
متن کاملDislocation density reduction in GaN using porous SiN interlayers
The influence of a thin porous SiNX interlayer on the growth of GaN by metalorganic chemical vapor deposition (MOCVD) has been studied. The interlayer is deposited on a GaN template by introducing silane in the presence of ammonia into the MOCVD chamber, and a GaN overlayer is deposited on the interlayer. The SiNX interlayer produces inhomogeneous nucleation and lateral growth of the overlayer,...
متن کاملSimulation supported analysis of the effect of SiNx interlayers in AlGaN on the dislocation density reduction
In the last few years aluminium nitride (AlN) has attracted much attention due to its extremely large direct band gap of approximately 6.0 eV and its impressive chemical and thermal stability. Thus AlN and AlxGa1-xN ternary alloys are promising materials for high-power high temperature electronic applications and optoelectronic devices in UV range. For group-III nitride wafers are still not ava...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2011