A numerical study of vortex ring formation at the edge of a circular tube
نویسنده
چکیده
An axisymmetric vortex-sheet model is applied to simulate an experiment of Didden (1979) in which a moving piston forces fluid from a circular tube, leading to the formation of a vortex ring. Comparison between simulation and experiment indicates that the model captures the basic features of the ring formation process. The computed results support the experimental finding that the ring trajectory and the circulation shedding rate do not behave as predicted by similarity theory for starting flow past a sharp edge. The factors responsible for the discrepancy between theory and observation are discussed.
منابع مشابه
Analysis of Flow Pattern with Low Reynolds Number around Different Shapes of Bridge Piers, and Determination of Hydrodynamic Forces, using Open Foam Software
In many cases, a set of obstacles, such as bridge piers and abutments, are located in the river waterway. Bridge piers disrupt river’s normal flow, and the created turbulence and disturbance causes diversion of flow lines and creates rotational flow. Geometric shape and position of the piers with respect to flow direction and also number of piers and their spacing are effective on changing the ...
متن کاملAn Experimental Investigation of the Flowfield over a Low Aspect Ratio Wing
A wind tunnel investigation was performed to study the flow field over a 70° swept sharped edge delta wing model at high angles of attack. The experiments were conducted in the subsonic wind tunnel at the Department of Mechanical Engineering, Sharif University of Technology. Velocity profiles have been measured using a special pitot tube and hot wire anemometer at angles of attacks of 10 to 35 ...
متن کاملAn Experimental Investigation of the Flowfield over a Low Aspect Ratio Wing
A wind tunnel investigation was performed to study the flow field over a 70° swept sharped edge delta wing model at high angles of attack. The experiments were conducted in the subsonic wind tunnel at the Department of Mechanical Engineering, Sharif University of Technology. Velocity profiles have been measured using a special pitot tube and hot wire anemometer at angles of attacks of 10 to 35 ...
متن کامل2D Numerical Simulation of a Micro Scale Ranque-Hilsch Vortex Tube
In this study, fluid flow and energy separation in a micro-scale Ranque-HilschVortex Tube are numerically investigated. The flow is assumed as 2D, steady,compressible ideal gas, and shear-stress-transport SST k-W is found to be a bestchoice for modeling of turbulence phenomena. The results are in a good agreementwith the experimental results reported in the literature. The results show that f...
متن کاملEffects Of Frequency Variation At Inlet Flow On The Vortex Shedding Frequency Behind A Circular Cylinder
In many applications the flow that past bluff bodies has frequency nature (oscillated) and it is not uniform. This kind of flow has effects on the formation of vortex shedding behind bluff bodies. In this paper the flow around a circular cylinder was numerically simulated. The effects of frequency variation at inlet flow on the vortex shedding frequency were investigated. The transient Two-Dime...
متن کامل