Calibrating the microStar
نویسنده
چکیده
Before you begin making measurements the microStar should be calibrated to your specific environment. This process, (i.e. creating a calibration curve) is extremely important as it correlates the optical response from a dosimeter to a known dose in order to establish the sensitivity of the system (measured in counts/dose). Fortunately, this is simple to do and the results can be stored for later use. The process has the following steps:
منابع مشابه
PTOSL response of commercial Al2O3:C detectors to ultraviolet radiation.
The photo-transferred optically stimulated luminescence (PTOSL) technique using Al2O3:C detectors has been suggested as a good option for ultraviolet (UV) radiation dosimetry. The objective of this work was to study the PTOSL response of Al2O3:C InLight detectors and the OSL microStar reader of Landauer. The parameters such as radiation pre-dose, optical treatment time and UV illumination time ...
متن کاملA comparative review of camera calibrating methods with accuracy evaluation
Camera modelling and calibrating is a crucial problem for further metric measuring of a scene. A lot of different calibrating techniques and surveys about calibration have been presented in last years. However, it is still difficult to go into details of a determined calibrating technique and to compare it with respect to the others. Mainly, this problem emerges due to the lack of notation stan...
متن کاملAccuBridgeTM A SELF CALIBRATING DC CUREENT COMPARATOR RESISTANCE BRIDGE
An optimized room temperature resistance bridge (AccuBridgeTM), modeled after the cryogenic current comparator, has been developed to determine current ratio’s with the highest accuracy. The direct current comparator has been optimized to reduce the leakage effects of the comparator. In addition, new self calibrating direct current sources have been fabricated and tested. AccuBridgeTM relies on...
متن کاملCalibrating a 4-wheel mobile robot
When a mobile robot is constructed the odometry must be calibrated. Calibrating a 4-wheel robot requires the accurate measurement of steering angle as well as translation and rotation. Some measurements are made with a tape measure and some with ultrasonic sensors. The measurements are used to determine the parameters of the odometry calibration matrix and the steering kinematic model. A proced...
متن کاملA Parallel Shuffled Complex Evolution Model Calibrating Algorithm to Reduce Computational Time
The Shuffled Complex Evolution (SCE-UA) method has been widely applied for calibration of rainfall-runoff models and has been shown to be robust and efficient search algorithm. In spite of its superiority, since many commonly used rainfallrunoff models have large simulation times, the use of model calibrating algorithms may become impractical due to the high computational time involved. This wo...
متن کامل