Measurement of Mine Dust Deposited on Sanded Acrylic Surfaces under Bonding Conditions at the 4600 * Laboratory
نویسنده
چکیده
Abstract: The mine dust deposited on sanded surfaces of test samples in the acrylic bonding exercise of March, 1992 was found by x-ray fluorescence analysis to be 0.05 (+0.07, -0.05) ng/cm2. This is well below the level at which mine dust in bonded joints would present a problem for SNO. The efficiency of the adhesive tape used in the XRF analysis for the removal of mine dust from a sanded surface has been measured and found to be greater than 90% (fraction of mass).
منابع مشابه
Investigation of Sanded Acrylic Surfaces by Optical Microscopy
Sanded acrylic surfaces have been examined with optical microscopy for evidence of grit embedded by the sanding process. The number of surface imperfections (pits or particles) larger than 5 microns was a factor of two to three times larger in the sanded surface than on a surface that had not been sanded. It was usually possible to distinguish an empty pit from a foreign particle, and the analy...
متن کاملEvaluation of heavy metals from desert dust in rangeland ecosystems of Khuzestan province
Extended abstract 1- Introduction Desert dust is formed under the influence of special weather and environmental conditions in desert areas and enters the atmosphere. Local hurricanes caused by surface air instability, passing through dry deserts, remove silt and sand particles from the surface and enter the atmosphere. Desert dust physically, in addition to its ecological effects such as lun...
متن کاملمقایسه سه سیستم self-etch adhesive در استحکام برشی باند کامپوزیتبه مینا در شرایط خشک و مرطوب
Background and Aim: The bonding mechanisms of self etching primers, based upon the simultaneous etching and priming of dentin, simplifies the bonding technique, but the efficiency of these systems is still controversial. This study compared the shear bond strength of three self etch adhesive systems in dry and wet conditions. Materials and Method: In this experimental study, 77 intact bovine lo...
متن کاملThe hydrogen bonding-driven self-assembly of PEGylated organosilica nanoparticles with
PEGylated organosilica nanoparticles have been synthesized through selfcondensation of 3-mercaptopropyltrimethoxysilane in dimethylsulfoxide into thiolated nanoparticles with their subsequent reaction with methoxypolyethylene glycol maleimide. The PEGylated nanoparticles showed excellent colloidal stability over a wide range of pHs in contrast to the parent thiolated nanoparticles, which have a...
متن کاملEffects of Light-cured versus No-mix and Self-etch Primer Adhesives on Enamel Discoloration following Orthodontic Bracket Bonding
Introdouction: According to the importance of enamel discoloration and controversy regarding the effect of different orthodontic bonding materials on tooth discoloration, the aim of this study was to determine enamel discoloration following orthodontic brackets using different bonding materials. Materials and methods: This in-vitro study, 30 recently extracted human premolars with inta...
متن کامل