A Paper of Determination of Controlling Characteristics of the Monopolar HVDC System
نویسندگان
چکیده
Due to cost effectiveness and less electrical fault hazards, the HVDC transmission is more suitable for long distance power transmission than that for the conventional AC transmission system. Moreover the utilization of power electronics has made HVDC technology competitive and reliable in comparison to HVAC system. The controlling mechanism of the DC link (either monopolar or bipolar) is the major concern for HVDC technology. Determination of control loop for system operation needs to commensurate with the conduction period of the semiconductor switching device. Generally IGBT and MOSFET are widely used as switching device whose delay angle, advance angle and extinction angle need to be matched with the controlling mechanism of the converter and inverter section. In this paper, the controlling characteristics of a monopolar HVDC system are determined by using MATLAB/Simulink. The Simpower tool box is used for designing the controlling blocks of the HVDC system. The controlling characteristics of the monopolar HVDC system can be determined from the simulation results of the gate currents of IGBT, output voltages of converter and inverter and modulation index.
منابع مشابه
Dynamic Harmonic Modeling and Analysis of VSC-HVDC Systems
Harmonics have become an important issue in modern power systems. The widespread penetration of non-linear loads to emerging power systems has turned power quality analysis into an important operation issue under both steady state and transient conditions. This paper employs a Dynamic Harmonic Domain (DHD) based framework for dynamic harmonic analysis of VSC-HVDC systems. These systems are wide...
متن کاملOn DC-Segmentation of Interconnected Power Systems
The ultimate goal of power system operation and planning is to increase power system reliability which enforces interconnected operation of power system. As a result of power system interconnection, the inter-area oscillation under different disturbances may cause power system partial or total blackout. DC-segmentation of interconnected power systems is a solution in which the topology of the n...
متن کاملPerformance Investigation of a Monopolar HVDC Transmission System Feeding a Weak AC Network
This paper investigates the performance of line commutated converter (LCC) based monopolar HVDC transmission system feeding a weak AC network with hybrid reactive power compensators (RPC’s) at the inverter AC side. The hybrid compensator is an equal mix of any two of the following compensators: synchronous compensator (SC); static var compensator (SVC); static synchronous compensator (STATCOM)....
متن کاملSynthesis of zirconium carbide nanoparticles by sol-gel method and determination of powder characteristics
In this study, zirconium carbide nanoparticles were synthesized by the sol-gel method in the alcoholic system. The sol was prepared in a three-component alkoxide-water-alcohol system based on the chemical sol-gel process under acidic conditions and at pH = 5. Zirconium n-propoxide, furfuryl alcohol were used as raw materials. After the hydrolysis process and formation of the gel, the initial po...
متن کاملOptimal characteristics determination of engine mounting system using TRA mode decoupling with emphasis on frequency responses
It is possible to improve vehicle vibration by tuning the parameters of engine mounting system. By optimization of mount characteristics or finding the optimal position of mounts, vibration of the engine and transmitted force from the engine to the chassis can be reduced. This paper examines the optimization of 6-degree-of-freedom engine mounting system based on torque roll axis (TRA) mode deco...
متن کامل