LC and LC-MS study on establishment of degradation pathway of glipizide under forced decomposition conditions.

نویسندگان

  • Gulshan Bansal
  • Manjeet Singh
  • K C Jindal
  • Saranjit Singh
چکیده

Forced degradation studies on glipizide are conducted under the conditions of hydrolysis, oxidation, photolysis, and dry heat. The solutions are subjected to liquid chromatographic (LC) investigations to establish the number of products formed in each condition. The degradation products are characterized through isolation and subsequent NMR, IR, and MS spectral analyses, or through LC-mass spectrometry (MS) fragmentation pattern study. The drug is shown to degrade in 0.1M HCl at 85 degrees C to two products: 5-methyl-N-[2-(4-sulphamoylphenyl)ethyl]pyrazine-2-carboxamide (II) and methyl N-[4-[2-{(5-methyl-2-pyrazinoyl)amino}ethyl] phenyl]sulfonyl carbamate (III). The latter, a methyl ester, is formed only in the presence of methanol (used as a solubilizer), and does not appear on use of acetonitrile. III is shown to convert to II on continued heating in acid. The drug degrades slowly in water at the same temperature, and both II and III could be seen in the chromatograms until the end of the study. The heating of the drug in alkali (0.1M NaOH) at 85 degrees C yields 5-methyl-2-pyrazinecarboxylic acid (IV), along with a small quantity of 4-(2-aminoethyl) benzenesulfonamide (I). On extended heating in the same condition, a new product, 4-(2-aminoethyl)-N,N-bis[(cyclohexylamino)carbonyl] benzenesulfonamide (VI) is formed in small quantities. At the lower temperature of 40 degrees C, the drug converts under each hydrolytic condition and in both the absence and presence of light to products II, III, or IV, along with a new product, 1-cyclohexyl-3-[[4-(2aminoethyl)phenyl] sulfonyl]urea (V). The light catalyzes formation of V, and it is formed until one or two weeks, after which its level decreases. The drug remains stable in 30% H2O2, except that products II and III appear as small peaks due to acidic character of the peroxide solution. Also, the drug remains unaffected in solid state under thermal and photolytic stress conditions. Based on the results, a more complete picture on degradation pathway of the drug is obtained, highlighting a clear advantage of the approach suggested by International Conference on Harmonization.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Identification of Forced Degradation Products of Itopride by LC-PDA and LC-MS

Degradation products of itopride formed under different forced conditions have been identified using LC-PDA and LC-MS techniques. Itopride was subjected to forced degradation under the conditions of hydrolysis, photolysis, oxidation, dry and wet heat, in accordance with the International Conference on Harmonization. The stress solutions were chromatographed on reversed phase C18 (250×4.6 mm, 5 ...

متن کامل

Establishment of inherent stability of pramipexole and development of validated stability indicating LC–UV and LC–MS method

Pramipexole belongs to a class of nonergot dopamine agonist recently approved for the treatment of early and advanced Parkinson's disease. A validated specific stability indicating reversed-phase liquid chromatographic method has been developed for the quantitative determination of pramipexole in bulk as well as in pharmaceutical dosage forms in the presence of degradation products. Forced degr...

متن کامل

LC, MSn and LC–MS/MS studies for the characterization of degradation products of amlodipine

In the present study, comprehensive stress testing of amlodipine (AM) was carried out according to International Conference on Harmonization (ICH) Q1A(R2) guideline. AM was subjected to acidic, neutral and alkaline hydrolysis, oxidation, photolysis and thermal stress conditions. The drug showed instability in acidic and alkaline conditions, while it remained stable to neutral, oxidative, light ...

متن کامل

Separation and characterization of forced degradation products of abacavir sulphate by LC-MS/MS.

Abacavir sulphate was subjected to forced degradation under the conditions of hydrolysis (acid, alkali and neutral), oxidation, photolysis and thermal stress as prescribed by ICH. Eight degradation products were formed and their separation was accomplished on Waters XTerra C₁₈ (250 mm x 4.6 mm, 5 μm) column using 20 mM ammonium acetate:acetonitrile as a mobile phase in gradient elution mode by ...

متن کامل

Forced Degradation Behaviour of Fluphenazine Hydrochloride by LC and Characterization of its Oxidative Degradation Product by LC–MS/MS

A novel, stability-indicating high-performance liquid chromatographic (HPLC) method is delivered for the determination of fluphenazine hydrochloride (FPZ) and its degradation products. The forced degradation testing of FPZ was carried out for hydrolytic, oxidative, photolytic, and thermal degradation. The degradation appeared using a reversed-phase C18 column at ambient temperature with a mobil...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of chromatographic science

دوره 46 6  شماره 

صفحات  -

تاریخ انتشار 2008