Grain growth and void formation in dielectric-encapsulated Cu thin films
نویسندگان
چکیده
Grain growth in 40-nm-thick Cu films encapsulated by overand under-layers of SiO2, Al2O3, Si3N4, and MgO was investigated. The films were magnetron sputter deposited onto cooled SiO2/Si substrates in an ultrahigh vacuum purity environment. Ex situ annealing was performed at 400 and 800 °C in 1 atm reducing gas. Films deposited at −120 °C exhibited more extensive grain growth after annealing than films deposited at −40 °C. Films annealed at room temperature had grain sizes less than 35 nm. All films exhibited some void formation after annealing at 400 and 800 °C, but the films encapsulated in Al2O3 exhibited the lowest area fraction of voids. The mean grain sizes of the Al2O3-encapsulated films, as measured by the linear intercept method, were 86 and 134 nm after annealing at 400 and 800 °C, respectively.
منابع مشابه
Growth, Characterization of Cu Nanoparticles Thin Film by Nd: YAG Laser Pulses Deposition
We report the growth and characterization of Cu nanoparticles thin film of on glass substrate by pulse laser deposition method. The Cu thin film prepared with different energy 50, 60, 70, and 80 mJ. The energy effect on the morphological, structural and optical properties were studied by AFM, XRD and UV-Visible spectrophotometer. Surface topography studied by atomic force microscopy revealed na...
متن کاملMicrostructural Analysis of Copper Thin Films for Characterization of Stress-induced Voiding Mechanisms
The amount of twin formation of electroplated and thermally treated copper thin films was evaluated by electron back-scattering diffraction (EBSD) analysis. The result establishes the importance of twin formation in the analysis of stress-induced voiding, and indicates that with the inclusion of a copper alloy co-element, twin formation was significantly reduced relative to pure-copper. Further...
متن کاملThe Effect of Target Purities on Grain Growth in Sputtered Copper Thin Films
Grain growth rates in sputtered Cu thin films were found to be influenced by impurity levels of the sputtering targets. The Cu thin films with thickness of 100 nm or 1mm were deposited on the rigid substrates by a sputter-deposition technique using the Cu target with purity of 99.99% (4N) or 99.9999% (6N), then subsequently annealed at room temperatures. The microstructures of the Cu films were...
متن کاملEffect of Organic Additives on Formation and Growth Behavior of Micro-Void in Electroplating Copper Films
To understand a void formation mechanism in electroplated Cu interconnects used for Si-ULSI (ultra-large scale integrated) devices, microstructures of Cu films which were prepared by the electroplating technique using plating baths with or without organic additives were investigated by transmission electron microscopy (TEM). In the as-deposited samples, a high density of micro-voids were observ...
متن کاملGrain Growth Mechanism of Cu Thin Films
Since Cu was found to be attractive as interconnect materials for ultra-large scale integrated (ULSI) Si devices, the electrical properties of Cu films have been extensively studied to prepare low resistance films. It was found in our previous papers that reduction of the electrical resistance of the Cu films was achieved by increasing grain sizes of the Cu films and large-grained Cu films were...
متن کامل