Dependences of High Magnetic Permeability on Crystal Magnetic Anisotropy and Magnetostriction
نویسنده
چکیده
Recently the present author(8) obtained an initial permeability of 24500 and a maximum permeability of 93000 by slowly cooling NiMn alloys of less than about 24% manganese from temperatures above the order-disorder transformation point after homogenizing treatment in high-temperature hydrogen or by further baking the alloys at temperatures below the order-disorder transformation point. The present investigation was carried out to determine the relationship between permeability and
منابع مشابه
ناهمسانگردی چهتی مغناطوتنگش وگذارفاز مغناطیسی درمحلول جامدNd14 Dy2 Fe78 B6
In this research. The magnetic phase transition and anisotropic magnetoelastic effects of a polycrystalline sample of Nd14Dy2Fe78B6 were studied by susceptibility and magnetostriction measurements. The composition was prepared by casting method. SEM pictures and XRD analysis showed that it was composed of polycrystalline magnetic phases with the main phase of 2-14-1. Results of ac susceptibil...
متن کاملVariation of magnetostriction with temperature in Tb5Si2.2Ge1.8 single crystal
The Tb5(SixGe4−x) alloy system is similar to the better known Gd5(SixGe4−x), except it has a more complex magnetic and structural phase diagram. Gd5(SixGe1−x)4 has received much attention recently due to its giant magnetocaloric effect, colossal magnetostriction and giant magnetoresistance in the vicinity of a first order combined magnetic-structural phase transition. The magnetostriction chang...
متن کاملMagnetostriction of Ni2Mn1−xCrxGa Heusler Alloys
Among the functionalities of magnetic Heusler alloys, magnetostriction is attracting considerable attention. The alloy Ni2MnGa has a premartensite phase, which is a precursor state to the martensitic transition. Some researchers have observed magnetostriction in this alloy in the premartensite phase. We performed magnetostriction studies on the premartensite phase of related Cr-substituted Ni2M...
متن کاملFabrication of Fe-based ribbon with controlled permeability by Joule heating under tensile stress
We prepared an Fe-based ribbon with controlled permeability and low magnetic loss by Continuous Stress-Annealing by Joule Heating (CSA-JH) method. The shortest annealing time necessary for the obtaining of the ribbons with completely developed anisotropy was 1 sec, but in order to obtain the sufficiently crystallized ribbons with small saturation magnetostriction it is required to perform annea...
متن کاملNondestructive evaluation of residual stresses in case hardened steels by magnetic anisotropy measurements
This paper reports on a recent study aimed at developing the stress-induced magnetic anisotropy (SMA) technique for characterizing residual stresses in case hardened steel components. The results of SMA measurements performed on flat induction hardened steel discs with different case depths confirm the feasibility of detecting principal stress axes by measuring the angular variation of magnetic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010