Application of Carbon Based Nano-Materials to Aeronautics and Space Lubrication

نویسنده

  • Kazuhisa Miyoshi
چکیده

The tribology program at NASA Glenn Research Center in Cleveland, Ohio, is investigating carbon based nano-particles for their potential in advanced concept lubrication products. Service conditions range from high temperature atmospheric to low temperature vacuum. Some of the lubricants and surface coatings of tribological significance that we have evaluated include neat nano-particles, both grown insitu and as bulk material deposited on the substrate, and nano-particles dispersed in oils which are all highly substrate interactive. We discuss results of testing these systems in a spiral orbit tribometer (SOT) and a unidirectional pin-on-disc (PoD) tribometer. A Nano-onions/Krytox mixture evaluated as a lubricant for angular contact bearings in air caused a marked lowering of the coefficient of friction (CoF) (0.04 to 0.05) for the mixture with an eight-fold improvement in lifetime over that of the Krytox alone. In vacuum, no effect was observed from the nanoonions. Multi-walled nanotubes (MWNT) and graphitized MWNT were tested under sliding friction in both air and vacuum. The MWNT which were grown in-situ oriented normal to the sliding surface exhibited low CoF (0.04) and long wear lives. Bulk MWNT also generate low CoF (0.01 to 0.04, vacuum; and 0.06, air) and long wear life (>1 million orbits, vacuum; and >3.5 million, air). Dispersed GMWNT were superior to MWNT and both were superior to aligned MWNT indicating that orientation is not an issue for solid lubrication. Single-walled nanotubes (SWNT) were modified by cutting into shorter segments and by fluorination. All SWNTs exhibited low CoF in air, with good wear lives. The SWNT with slight fluorination yielded an ultra-low CoF of 0.002 although the best wear life was attributed to the nascent SWNT.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effects of Replacing Fluorine with Sodium and Titanium Oxides on Continuous Casting of Steel Mold Powders Lubrication

Mold powders are used as raw materials in continuous casting of steel industry; Also they are mostly composed of aluminum, calcium, silica oxides, alkaline and earth-alkaline oxides along with carbon and fluor. Two of the most important duties of mold powders are the lubrication of the space between mold walls and steel shell, and heat transfer control between steel shell and the copper mold. F...

متن کامل

Nano and Micro PTFE for Surface Lubrication of Carbon Fabric Reinforced Polyethersulphone Composites

Abstract Carbon fibre/fabric (CF) is a privileged reinforcement for advanced polymer composites in tribological applications where performance is primary criteria rather than the cost due to the combination of distinct properties such as high specific strength, thermo-oxidative resistance, thermal and electrical conductivity along with self-lubricity etc. However problems associated with its ch...

متن کامل

Improved Tribological Performance of Amorphous Carbon (a-C) Coating by ZrO2 Nanoparticles

Nanomaterials, such as Graphene, h-BN nanoparticles and MoS₂ nanotubes, have shown their ability in improving the tribological performance of amorphous carbon (a-C) coatings. In the current study, the effectiveness of ZrO₂ nanoparticles (ZrO₂-NPs) in lubricating the self-mated nonhydrogenated a-C contacts was investigated in boundary lubrication regime. The results showed that 13% less friction...

متن کامل

Free Vibration of Lattice Cylindrical Composite Shell Reinforced with Carbon Nano-tubes

The free vibration of the lattice cylindrical composite shell reinforced with Carbon Nano-tubes (CNTs) was studied in this study. The theoretical formulations are based on the First-order Shear Deformation Theory (FSDT) and then by enforcing the Galerkin method, natural frequencies are obtained. In order to estimate the material properties of the reinforced polymer with nano-tubes, the modified...

متن کامل

Nano-Hybrids Based on Surface Modified Reduced Graphene Oxide Nanosheets and Carbon Nanotubes and a Regioregular Polythiophene

    The multi-walled carbon nanotubes (CNTs) and reduced graphene oxide (rGO) nanosheets were functionalized with 2-hydroxymethyl thiophene (CNT-f-COOTh) and 2-thiophene acetic acid (rGO-f-TAA) and grafted with poly(3-dodecylthiophene) (CNT-g-PDDT and rGO-g-PDDT) to manipulate the orientation and patterning of crystallized regioregular poly(3-hexylthiophene) (P3HT). Distinct nano-hybrid structu...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007