Contact area and pressure distribution in the feline patellofemoral joint under physiologically meaningful loading conditions.

نویسندگان

  • A L Clark
  • W Herzog
  • T R Leonard
چکیده

The purpose of this study was to determine contact area and mean and peak pressures in the healthy feline patellofemoral joint over the complete range of possible applied force. Furthermore, we wanted to improve upon the repeatability of previous measurements while maximizing the physiological relevance of the results obtained. The patellae and femora were secured in a loading frame approximating an in situ loading configuration. Low- and medium-grade Fuji film was used to assess patellofemoral contact area and pressure distribution, respectively. Constant force was applied to the patellofemoral joints for 2s (short duration trials) or 5min (long duration trials). For the short duration trials, contact area was shown to increase logarithmically with the force applied. In contrast, mean and peak pressures increased linearly with force. Furthermore, the rate of increase of peak pressure with force was approximately three times greater than that of mean pressure. For the long duration trials, contact area increased up to 33% compared to the short duration trials. This effect could no longer be detected with our approach after an unloading period of 5-10s. Increasing contact area is one mechanism that the feline patellofemoral joint may use to regulate the pressures experienced by the cartilage as the force applied to the joint increases. The attenuation of external forces inside a joint is achieved by the specific geometry of the articulating surfaces and the viscoelastic properties of the articular cartilage. It likely represents a natural protection of joints to high external load magnitudes.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Regulation of the Patellofemoral Contact Area: an Essential Mechanism for Maintaining Physiological Patellofemoral Joint Kinetics?

INTRODUCTION: Reduced patellofemoral (PF) contact area, elevated pressure and increased patellar tilt are often associated with anterior knee pain. Therefore, quantification of biomechanical parameters that characterize both the kinematics and the kinetics of the joint in an experimental, as well as clinical setting, is of increasing importance. Whilst a number of approaches have been suggested...

متن کامل

Effects of patellar resurfacing on contact area and contact stress in total knee arthroplasty.

The objective of this study was to examine the effects of patellar resurfacing on patellofemoral joint contact pressure and contact area in total knee arthroplasty. We tested seven fresh-frozen cadaveric knees using a custom knee jig which permits the simulation of physiologic quadriceps loading. Before patellar resurfacing, the mean peak contact pressure of medial and lateral patellofemoral jo...

متن کامل

Patellofemoral joint contact area increases with knee flexion and weight-bearing.

Patellofemoral pain is a common and debilitating disorder. Elevated cartilage stress of the patellofemoral joint is hypothesized to play a role in the onset of pain. Estimating cartilage stress requires accurate measurements of contact area. The purpose of this study was to estimate patellofemoral joint contact areas in a group of healthy, pain-free subjects during upright, weight-bearing condi...

متن کامل

Weight-bearing MRI of patellofemoral joint cartilage contact area.

PURPOSE To measure contact area of cartilage in the patellofemoral joint during weight bearing using an open MRI scanner. MATERIALS AND METHODS We developed an MR-compatible back support that allows three-dimensional imaging of the patellofemoral cartilage under physiologic weight-bearing conditions with negligible motion artifact in an open MRI scanner. To measure contact areas, we trained o...

متن کامل

In vitro method for assessing the biomechanics of the patellofemoral joint following total knee arthroplasty.

The patellofemoral joint is a common site of pain and failure following total knee arthroplasty. A contributory factor may be adverse patellofemoral biomechanics. Cadaveric investigations are commonly used to assess the biomechanics of the joint, but are associated with high inter-specimen variability and often cannot be carried out at physiological levels of loading. This study aimed to evalua...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of biomechanics

دوره 35 1  شماره 

صفحات  -

تاریخ انتشار 2002