Conductance in Co|Al2O3|Si|Al2O3 Permalloy with asymmetrically doped barrier
نویسندگان
چکیده
Citation Guerrero, R. et al. "Conductance in Co/Al2O3/Si/Al2O3 permalloy with asymmetrically doped barrier. Article is made available in accordance with the publisher's policy and may be subject to US copyright law. Please refer to the publisher's site for terms of use. The MIT Faculty has made this article openly available. Please share how this access benefits you. Your story matters.
منابع مشابه
Spin manipulation in Co-doped ZnO.
We report the clearly observed tunneling magnetoresistance at 5 K in magnetic tunnel junctions with Co-doped ZnO as a bottom ferromagnetic electrode and Co as a top ferromagnetic electrode prepared by pulsed laser deposition. Spin-polarized electrons were injected from Co-doped ZnO to the crystallized Al2O3 and tunnelled through the amorphous Al2O3 barrier. Our studies demonstrate the spin pola...
متن کاملSilicon diffusion control in atomic-layer-deposited Al2O3/La2O3/Al2O3 gate stacks using an Al2O3 barrier layer
In this study, the physical and electrical characteristics of Al2O3/La2O3/Al2O3/Si stack structures affected by the thickness of an Al2O3 barrier layer between Si substrate and La2O3 layer are investigated after a rapid thermal annealing (RTA) treatment. Time of flight secondary ion mass spectrometry (TOF-SIMS) and X-ray photoelectron spectroscopy (XPS) tests indicate that an Al2O3 barrier laye...
متن کاملLow frequency noise in Co/Al2O3〈δ(Fe)〉/Ni80Fe20 magnetic tunnel junctions
Abstract The time dependences, up to 200 s, and the noise power spectrum (0.005–10 Hz) in the electron transport response at bias up to 300 mV of Co/Al2O3/Ni80Fe20 magnetic tunnel junctions (MTJs) and of Co/Al2O3〈δ(Fe)〉/Ni80Fe20 (with Fe δ dopants of thickness 1.8 Å inside the barrier) were investigated. The magnetic field was changed between +100 and −100 G in steps of 1 G. The measurements we...
متن کاملOptimization of Low-Loss Al2O3 Waveguide Fabrication for Application in Active Integrated Optical Devices
In this paper we will present the fabrication and properties of reactively co-sputtered Al2O3 layers, being a very promising host material for active integrated optics applications such as rare-earth ion doped laser devices. The process optimization towards a reactive co-sputtering process, which resulted in stable, target condition-independent deposition of Al2O3 layers with high optical quali...
متن کاملCooperative upconversion as the gain-limiting factor in Er doped miniature Al2O3 optical waveguide amplifiers
Erbium doped Al2O3 waveguide amplifiers were fabricated using two different doping methods, namely Er ion implantation into sputter deposited Al2O3 , and co-sputtering from an Er2O3 /Al2O3 target. Although the Er concentration in both materials is almost identical ~0.28 and 0.31 at. %!, the amplifiers show a completely different behavior. Upon pumping with 1.48 mm, the co-sputtered waveguide sh...
متن کامل