Emissivity Measurements of Foam-Covered Water Surface at L-Band for Low Water Temperatures

For a foam-covered sea surface, it is difficult to retrieve sea surface salinity (SSS) with L-band brightness temperature (1.4 GHz) because of the effect of a foam layer with wind speeds stronger than 7 m/s, especially at low sea surface temperature (SST). With foam-controlled experiments, emissivities of a foam-covered water surface at low SST (−1.4 °C to 1.7 °C) are measured for varying SSS, foam thickness, incidence angle, and polarization. Furthermore, a theoretical model of emissivity is introduced by combining wave approach theory with the effective medium approximation method. Good agreement is obtained upon comparing theoretical emissivities with those of experiments. The results indicate that foam parameters have a strong influence on increasing emissivity of a foam-covered water surface. Increments of experimental emissivities caused by foam thickness of 1 cm increase from about 0.014 to 0.131 for horizontal polarization and 0.022 to 0.150 for vertical polarization with SSS increase and SST decrease. Contributions of the interface between the foam layer and water surface to OPEN ACCESS Remote Sens. 2014, 6 10914 the foam layer emissivity increments are discussed for frequencies between 1 and 37 GHz.