Inverse - feedforward of charge - controlled piezopositioners q , qq
نویسندگان
چکیده
Inverse-feedforward control can substantially improve the performance of piezoelectric positioners (piezopositioners). The feedforward-input is found by modeling and inverting the piezopositioner dynamics. The primary challenge in such an approach is the complexity of modeling and inverting the hysteresis nonlinearity in the piezopositioner dynamics. The main contribution of this work is to alleviate this complexity by using charge control to linearize the overall dynamics and then model and invert the simplified (linearized) dynamics. The proposed approach is applied to an experimental piezopositioner and results are presented to contrast the feedforwardbased positioning performance with and without the use of charge control to linearize the dynamics. 2007 Elsevier Ltd. All rights reserved.
منابع مشابه
An inverse eigenproblem for generalized reflexive matrices with normal $k+1$-potencies
Let P, Q ∈ C be two normal {k+1}-potent matrices, i.e., PP ∗ = P P, P k+1 = P , QQ = QQ, Q = Q, k ∈ N. A matrix A ∈ C is referred to as generalized reflexive with two normal {k + 1}-potent matrices P and Q if and only if A = PAQ. The set of all n × n generalized reflexive matrices which rely on the matrices P and Q is denoted by GR(P,Q). The left and right inverse eigenproblem of such matrices ...
متن کاملHysteresis and Vibration Compensation in Piezoelectric Actuators by Integrating Charge Control and Inverse Feedforward
In this paper we address the problems of hysteresis and vibrations that limit the accuracy of piezoelectric positioners. It is widely known that the use of charge control significantly reduces hysteresis, thus enabling high-accuracy positioning during low speed operations. However, charge control is unable to reduce vibrations that limit the positioning bandwidth. Our main contribution is to ov...
متن کاملErratum Some Speculations on the Pattern of Quark and Lepton Masses
Conclusion (3) on page 8 is incorrect. It should be replaced by the following: 3) Our best guess (assuming SU(2) symmetry) for the masses of fourth generation quarks Q is > 150 GeV. Such quarks may be produced in pp or pc colliding-beam experiments. For example for Ecms 2 2 TeV one might expect a QQ production cross section in the nanobarn range. Such a superheavy quark will decay into a light ...
متن کاملCovert channel vulnerabilities in anonymity systems
− −4 −3 −2 −1 0 q q q q q q q q q q q q q q q qq q q q q q q q q q q q q q q q q q qq q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q qq q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q qq q q q q q q q q q q q q q q q q q q q q q q q q...
متن کاملSimple relation for alpha decay half-lives.
The experimental values of log&pT, yp(sec) plotted vs Zz /QQ are shown to fall on a nearly universal straight line with log, oT, ~z(sec)=(9. 54Z~. /1/Q ) —51.37, where Zz is the charge number of the daughter nucleus and Q is expressed in units of MeV. This behavior also numerically comes out of the semiclassical WKB calculation of the barrier penetration factor. The fine structure in the ratio ...
متن کامل