Efficient Wideband High Gain Low Noise Amplifier in Modern Radars
نویسندگان
چکیده
in this paper a wideband single stage pseudomorphic high electron mobility transistor (PHMET) amplifier has been designed at 5.8 GHz, the input and output matching circuits have a pi form.Noise cancelling principle and sensitivity analysis are performed .Simulation results have been compared with their correspondence in [10] give 2.71 dB improvement in amplifier gain at the same noise figure (N.F) and input, output returns loss. A new optimized low noise amplifier (LNA) using PHEMT at 3 GHZ have been designed to achieve an improvements of 3.3 dB in amplifier gain and 1.81 dB in noise figure.Also the two stages (common gate in cascaded with common source) LNA have been analyzed and optimized for (1-16) GHz full band application to achieve maximum gain over a wide frequency band. Simulation results carried out sever improvement in amplifier gain over the results obtained for the two structures in [16-17] respectively with no change in N.F value .The improvement in optimized gain for the first and second structures are (3.278, 2.82) dB. The comparative study between the traditional and optimized structures showing a superior performance of LNA making them sutiable to be used in modern radar systems.
منابع مشابه
A High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملLow Noise Amplifier Application Using Negative Feedback for Ultra-wideband Applications
This paper presents a design of Ultra Wideband Low Noise Amplifier (LNA) with Negative Feedback and multisection matching network implementing on Microstrip design technique. The design started with selecting a transistor which is Super-low noise InGaAs HEMT MGF4937AM transistor that support ultra-wideband frequencies. In order to achieve ultra-wideband LNA, two different techniques which imple...
متن کاملRecent advances in Gain-Bandwidth trade-off for Ultra-Wideband 45-nm CMOS Low-Noise Amplifiers (LNAs)
In present day society where communication technologies are advancing at spiral rate, the need for efficient integrated circuit design to transmit and receive signals at unlicensed frequency spectrum is inevitable. This study tries to shed new light on the latter topic by evaluating the issues associated with the design in advanced CMOS technologies of a critical RF building block, namely a sin...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کامل