Biomechanical evaluation of a novel wheelchair backrest for elderly people
نویسندگان
چکیده
BACKGROUND Back pain is a common complication of wheelchair-bound elderly people. Seating system is a key factor that influences spinal curvature, back muscle activation, interface pressure, and comfortability. A seating system can maintain lumbar lordosis, lower back muscle activity, and decrease ischial tuberosities pressure, which reduces spinal load and directly influences sitting comfort. Our previous study has confirmed that backward thoracic support showed a relatively higher lumbar lordosis and lower back muscle activity. This study intends to evaluate the influence of backward thoracic support on interface pressure and subjective discomfort. METHODS In this study, 18 elderly men were recruited to participate in a random comparison involving 4 sitting postures. These postures comprised relaxed slouching, flat back support, prominent lumbar support, and backward thoracic support sitting. All parameters, including interface pressure (total contact area, average pressure, and peak pressure on backrest and seat) and subjective discomfort (upper-back, mid-back, lower-back, buttocks, and thighs) were measured and compared. RESULTS The results showed that compared with other sitting postures, backward thoracic support sitting significantly reduced average pressure and peak pressure on seat and increased average pressure and peak pressure on backrest. Concurrently, subjective discomfort in the upper-back, mid-back, lower-back, and buttocks were reduced. CONCLUSIONS The results confirmed that backward thoracic support can maintain favorable wheelchair sitting posture, thereby preventing or reducing the risks of back pain. However, this study was no evaluations on shear forces on butts and neck postures. Future studies investigating shear forces on butts and neck postures are required.
منابع مشابه
Biomechanics of manual wheelchair propulsion in elderly: system tilt and back recline angles.
OBJECTIVE To investigate the effects of the system tilt and back recline angles on the biomechanics of wheelchair propulsion for a group of older, disabled patients. It was hypothesized that increasing both the system tilt and backrest recline angles would have a positive effect on the biomechanical efficiency of manual wheelchair propulsion. DESIGN Three kinetic variables were estimated duri...
متن کاملComprehensive Needs Assessment Study and Deployment of QFD Targeted at New Wheelchair Design
Objectives: Extensive use of wheelchair increases caregiver dependency, risk of bedsores, risk of injury during transfer, and so on, and it effectively decreases quality of life, safety, and comfort of the people with disability. Therefore, improving the design of wheelchairs is highly essential in promoting the quality of life and level of participation among people with disability. The design...
متن کاملComparative biomechanical evaluation of different wheelchair seat cushions.
The aim of the present study was to perform a comparative biomechanical analysis of four antidecubitus wheelchair cushions. Thirty wheelchair users were considered divided into three groups: paraplegic subjects (with no cutaneous sensation), neurologic subjects (with intact cutaneous sensation), and elderly subjects. The biomechanical evaluation was performed using a piezoresistive sensor matri...
متن کاملA study on effects of backrest thickness on the upper arm and trunk muscle load during wheelchair propulsion
[Purpose] The purpose of this study was to investigate the effects of the thickness of a wheelchair backrest provided for support and comfort on upper arm and trunk muscle load during wheelchair propulsion by using accelerometers. [Subjects and Methods] The Fourteen healthy participants were enrolled in this study. The study compared effects of three backrest conditions including no pad, a 3-cm...
متن کاملThe effects of backrest thickness on the shoulder muscle load during wheelchair propulsion
[Purpose] This study investigated the optimal thickness of the wheelchair backrest for lumbar load and increased comfort. [Subjects] Fifteen healthy people participated. [Methods] The study examined three randomized backrest conditions: no pad; a 3-cm-thick lumbar pad; and a 6-cm-thick lumbar pad. The location of the lumbar pad was standardized at the mid-lumbar level (L3). Participants were in...
متن کامل