Micro-simulation of Desired Speed for Temporary Work Zone with a New Calibration Method
نویسنده
چکیده
Nowadays, the studies of parameter calibration for longterm work zones are limited to driver behaviour and car-following parameters, and no research was found related to calibration of the desired speed distributions during temporary work zones. Obtaining realistic results from simulations of temporary work zones is difficult. Thus, it would be valuable for gaining more valid simulation data if a method of calibrating the desired speed distribution could be applied for traffic simulation model of highway temporary work zones. The calibration method was proposed in five steps: (1) collect and analyse data, (2) plot the travel speed cumulative frequency curves and calibrate the desired speed distribution, (3) conduct simulation runs, (4) validate the simulation results, and (5) propose a new calibration method, which was assessed by T-tests, and the results are very promising. Finally, a simplified calibration method called “Five-Point Method” is presented and the recommended values of five-point are given.
منابع مشابه
Identification and Adaptive Position and Speed Control of Permanent Magnet DC Motor with Dead Zone Characteristics Based on Support Vector Machines
In this paper a new type of neural networks known as Least Squares Support Vector Machines which gained a huge fame during the recent years for identification of nonlinear systems has been used to identify DC motor with nonlinear dead zone characteristics. The identified system after linearization in each time span, in an online manner provide the model data for Model Predictive Controller of p...
متن کاملشبیهسازی المان محدود فرایند برش متعامد و تعیین ضخامت لایه چسبنده به ابزار در ناحیه دوم برش
The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...
متن کاملThree-Phase to Single-Phase Matrix Converters: New Topology Based on New Control Method
In this paper, a new topology is proposed for three-phase to single-phase matrix converters, where more voltage levels are produced in the output in comparison with the conventional topologies. In addition, a new control method based on minimum error between the generated and the desired output voltages is proposed for three-phase to single-phase matrix converters. In the proposed control metho...
متن کاملHigh Speed Delay-Locked Loop for Multiple Clock Phase Generation
In this paper, a high speed delay-locked loop (DLL) architecture ispresented which can be employed in high frequency applications. In order to design the new architecture, a new mixed structure is presented for phase detector (PD) and charge pump (CP) which canbe triggered by double edges of the input signals. In addition, the blind zone is removed due to the elimination of reset signal. Theref...
متن کاملAn Investigation on Effect of Shell Liner Type on Performance of Industrial SAG Mills Using DEM
The shell liner type, rotation speed, and ball filling percent are the key factors influencing the charge behavior inside the SAG mills, and consequently, their performance. In this work, the milling operation of industrial SAG mills is investigated using the Discrete Element Method (DEM). First, an industrial SAG mill with dimensions of 9.50 m × 4.42 m that has a Smooth-type liner is sim...
متن کامل