The effects of particle size and surface coating on the cytotoxicity of nickel ferrite.
نویسندگان
چکیده
The safety and toxicity of nanoparticles are of growing concern despite their significant scientific interests and promising potentials in many applications. The properties of nanoparticles depend not only on the size but also the structure, microstructure and surface coating. These in turn are controlled by the synthesis and processing conditions. The dependence of cytotoxicity on particle size and on the presence of oleic acid as surfactant on nickel ferrite particles were investigated in vitro using the Neuro-2A cell line as a model. For nickel ferrite particles without oleic acid prepared by ball milling, cytotoxicity was independent of particle size within the given mass concentrations and surface areas accessible to the cells. For nickel ferrite particles coated with oleic acid prepared by the polyol method, the cytotoxicity significantly increased when one or two layers of oleic acid were deposited. Large particles (150+/-50 nm diameter) showed a higher cytotoxicity than smaller particles (10+/-3 nm diameter).
منابع مشابه
The Effects of Cu and Zn Dopants on Phase Constituents, Magnetic Properties and Microstructure of Nickel Ferrite
In this research nanoparticles of Ni0.55Zn0.35Cu0.1Fe2O4 were synthesized by sol–gel auto-combustion method. Changes in phase constituents, microstructure and magnetic properties as a result of Zn and Cu additions were evaluated by X-ray diffraction (XRD), Field Emission Scanning Electron Microscope (FESEM), and Vibration Sample Magnetometer (VSM) techniques. XRD results show that the doped sam...
متن کاملChemical Synthesis of Nano-Crystalline Nickel-Zinc Ferrite as a Magnetic Pigment
The nano-crystalline nickel-zinc ferrite was prepared via chemical synthesis. Zinc nitrate, nickel nitrate, iron nitrate hydrate, citric acid and ethylene glycol were used as precursor materials. Crystallization behavior of the precursor was studied by X-ray diffraction (XRD). Nanoparticle phases can change amorphous to spinel ferrite depending on the calcination temperature and crystallite siz...
متن کاملAnticorrosive Performance of Polyester–melamine Coating Fortified with Zinc Ferrite Nanoparticles
In this study, nanoparticle zinc ferrites with different particle sizes were synthesized via sol-gel method using ferric nitrate and zinc nitrate. The obtained gel was dried and calcined at three different temperatures (i.e. 500, 600 and 800 °C) for 2 h. Adequate amounts of the as-synthesized nanoparticle samples were then added to the mixture of polyester resin and formaldehyde resin. The ...
متن کاملEffect of TiO2 Particle Concentration on Microstructure and Mechanical Properties of Ni-P-TiO2 Composite Coatings
Ferritic stainless steels are widely used in equipment, including parts in turbines, electrical industries, aerospace, automotive and decorating industries. One of the problems with this type of steels is their low wear resistance. One of the ways to overcome this problem is to apply a wear-resistant coating on the surface of steel. In this research, nickel phosphorus-titanium oxide coating was...
متن کاملSynthesis and Surfactant Effect on Structural Analysis of Nickel Doped Cobalt Ferrite Nanoparticles by C-precipitation Method
Nanoparticles of nickel substituted cobalt ferrite (Nix Co1-xFe2 O4 : 0£ X£ 1) have been synthesized by co-precipitation method. Triton x-100 and oleic acid as surfactants were used. Particles size as estimated by the full width half maximum (FWHM) of the strongest X-ray diffraction (XRD) peak were found 17 and 21nm. Their morphology structure have been determined by scanning electron microscop...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Biomaterials
دوره 26 29 شماره
صفحات -
تاریخ انتشار 2005