Spatial homogeneity of optically switched semiconductor photonic crystals and of bulk semiconductors
نویسندگان
چکیده
This paper discusses free carrier generation by pulsed laser fields as a mechanism to switch the optical properties of semiconductor photonic crystals and bulk semiconductors on an ultrafast time scale. Requirements are set for the switching magnitude, the time-scale, the induced absorption as well as the spatial homogeneity, in particular for silicon at λ = 1550 nm. Using a nonlinear absorption model, we calculate carrier depth profiles and define a homogeneity length lhom. Homogeneity length contours are visualized in a plane spanned by the linear and two-photon absorption coefficients. Such a generalized homogeneity plot allows us to find optimum switching conditions at pump frequencies near ν/c=5000 cm (λ = 2000 nm). We discuss the effect of scattering in photonic crystals on the homogeneity. We experimentally demonstrate a 10% refractive index switch in bulk silicon within 230 fs with a lateral homogeneity of more than 30 μm. Our results are relevant for switching of modulators in absence of photonic crystals.
منابع مشابه
Optically triggered Q-switched photonic crystal laser.
An optically triggered liquid crystal infiltrated Q-switched photonic crystal laser is demonstrated. A photonic crystal laser cavity was designed and fabricated to support two orthogonally polarized high-Q cavity modes after liquid crystal infiltration. By controlling the liquid crystal orientation via a layer of photoaddressable polymer and a writing laser, the photonic crystal lasing mode can...
متن کاملMacroporous materials electrochemically grown photonic crystals
Colloidal crystallization has been explored for several years as a fabrication method for photonic crystals. While macroporous materials grown with silica or polymer colloids might exhibit pleasing opalescence, truly novel photonic behavior such as photonic band-gaps, is expected only for very high index of refraction contrast systems. This can possibly be achieved through electrodeposition of ...
متن کاملFabrication of photonic band-gap crystals
We describe the fabrication of three-dimensional photonic crystals using a reproducible and reliable procedure consisting of electron beam lithography followed by a sequence of dry etching steps. Careful fabrication has enabled us to define photonic crystals with 280 nm holes defined with 350 nm center to center spacings in GaAsP and GaAs epilayers. We construct these photonic crystals by trans...
متن کاملLithographic band gap tuning in photonic band gap crystals
We describe the lithographic control over the spectral response of three-dimensional photonic crystals. By precise microfabrication of the geometry using a reproducible and reliable procedure consisting of electron beam lithography followed by dry etching, we have shifted the conduction band of crystals within the near-infrared. Such microfabrication has enabled us to reproducibly define photon...
متن کاملSemiconductor nanostructures via electrodeposition from ionic liquids*
The fascinating properties of ionic liquids make it possible to synthesize semiconductor nanostructures via a simple and low-cost electrochemical pathway. The present paper summarizes our recent work on the synthesis of Si, Ge, and SixGe1–x nanostructures from ionic liquids: thin films, nanowires and photonic crystals. We also introduce our first results on the template-assisted electrodepositi...
متن کامل