GA For Improved Dynamic Response Of DSTATCOM
نویسندگان
چکیده
The performance of D-STATCOM depends on capacitor voltage regulation. In D-STATCOM, the nonlinear controller is preferred to linear controller. Regulating and fixing the capacitor DC voltage in DSTATCOM can improve the system dynamic such as capacitor voltage response, current response and modulation index. The regulation of DC capacitor voltage based on optimal PI co-efficient. In conventional scheme, the trial and error method is used to determine PI values. In this paper genetic algorithm is applied for exact calculation of optimized PI co-efficient, to reduce disturbances in DC link voltage. Optimization and simulations are worked out in MATLAB environment
منابع مشابه
Dynamic Modeling and Controller Design of Distribution Static Compensator in a Microgrid Based on Combination of Fuzzy Set and Galaxy-based Search Algorithm
This paper presents a nonlinear controller for a Distribution Static Compensator (DSTATCOM) of a microgrid incorporating the Distributed Generation (DG) units. The nonlinear control has been designed based on partial feedback linearization theory and Proportional-Integral-Derivative (PID) controllers try to adjust the voltage and trace the output. This paper has proposed a combination of a fuz...
متن کاملDirect and Indirect Control Strategies of DSTATCOM Power Factor Controller
The device analyzed in this paper is Distribution STATic COMpensator (DSTATCOM). The objective is to focus on the power factor control with the two different control strategies i.e., Indirect and Direct Control Strategies. This paper presents a study about the control strategies of DSTATCOM device and their impact on the dynamic performance of distribution network. Simulation results were prese...
متن کاملPower Quality Improvement using DSTATCOM for Small Isolated Alternator feeding Distribution System
This paper demonstrates a perfect controlled DSTATCOM model with a small isolated distribution system to improve power quality of the system in which a linear/nonlinear three-phase load is fed by a small alternator. A hysteresis rule based carrier-less PWM current controller is used to control the DSTATCOM. Three leg IGBT based PWM-VSI is used as VSC with a capacitor in its parallel working as ...
متن کاملA New Control Strategy for Controlling Isolated Microgrid
Microgrid control in isolated mode is a highly important subject area. In the present paper, a new method is used for controlling the isolated microgrids. This method was used based on the classification of the microgrids into two groups, namely fast-dynamic (battery and flywheel) and slow-dynamic (diesel generator, electrolyzer, fuel cell). For the microgrid components with fast dynamics, a se...
متن کاملPerformance Evaluation of Transmission Line Protection Characteristics with DSTATCOM Implementation
To meet with the ever-enhancing load demands, new transmission lines should be bolted-on in the existing power system but the economic and environmental concerns are major constraints to this addition. Hence utilities have to rely on the existent power system infrastructure with some modifications. To enhance controllability and boost power transfer potential of the existing power system the us...
متن کامل