A low-power readout circuit for nanowire based hydrogen sensor

This paper presents a fully integrated lock-in amplifier intended for nanowire gas sensing. The nanowire will change its conductivity according to the concentration of an absorbing gas. To ensure an accurate nanowire impedance measurement, a lock-in technique is implemented to attenuate the low frequency noise and offset by synchronous demodulation or phase-sensitive detection (PSD). The dualchannel lock-in amplifier also provides both resistive and capacitive information of the nanowire in separate channels. Measurement results of test resistors and capacitors show a 2% resolution in the resistance range 10–40kO and a 3% resolution in the capacitance range 0.5–1.8 nF. Moreover, a 28.7–32.1 kO impedance variation was measured through the lock-in amplifier for a single palladium nanowire that was exposed to a decreasing hydrogen concentration (10% H2 in N2 to air). The chip has been implemented with UMC 0.18mm CMOS technology and occupies an area of 2mm. The power consumption of the readout circuit is 2mW from a 1.8 V supply. & 2010 Elsevier Ltd. All rights reserved.