Modeling micro - end - milling operations . Part II : tool run - out
نویسندگان
چکیده
The effect of run-out is clearly noticed in micro-end-milling operations, while the same run-out creates negligible change at the cutting force profile of conventional end-milling operations. In this paper, the cutting force characteristics of micro-end-milling operations with tool run-out are investigated. An analytical cutting force model is developed for micro-end-milling operations with tool run-out. The proposed model has a compact set of expressions to be able to estimate the cutting force characteristics very quickly compared to the numerical approaches. The cutting forces of micro-end-milling operations simulated by the proposed model had good agreement with the experimental data.
منابع مشابه
Modeling micro-end-milling operations. Part I: analytical cutting force model
A new analytical cutting force model is proposed for micro-end-milling operations. The model calculates the chip thickness by considering the trajectory of the tool tip while the tool rotates and moves ahead continuously. The proposed approach allows the calculation of the cutting forces to be done accurately in typical micro-end-milling operations with very aggressively selected feed per tooth...
متن کاملTool Run-Out Measurement in Micro Milling
The interest in micro manufacturing processes is increasing because of the need for components characterized by small dimensions and micro features. As a result, researchers are studying the limitations and advantages of these processes. This paper deals with tool run-out measurement in micro milling. Among the effects of the scale reduction from macro to micro, tool run-out plays an important ...
متن کاملModeling micro-end-milling operations. Part III: influence of tool wear
The characteristics of the cutting forces were studied at different usage levels and the analytical model of the micro-end-milling operations was modified to represent the tool wear. A new expression was derived from the model to estimate the remaining tool life from experimental data. The parameters of the model are estimated by using genetic algorithms. The difference between the simulated an...
متن کاملSwept Mechanism of Micro-Milling Tool Geometry Effect on Machined Oxygen Free High Conductivity Copper (OFHC) Surface Roughness
Cutting tool geometry should be very much considered in micro-cutting because it has a significant effect on the topography and accuracy of the machined surface, particularly considering the uncut chip thickness is comparable to the cutting edge radius. The objective of this paper was to clarify the influence of the mechanism of the cutting tool geometry on the surface topography in the micro-m...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کامل