Comparative Analysis of Stress Jumps in Metals and Intermetallic Compounds: I. Description of Two-Stage Straining
نویسندگان
چکیده
The Cottrell-Stokes two-stage straining of fcc metals and intermetallic compounds whose yield stress exhibits an anomalous temperature dependence is analyzed theoretically. The magnitude of stress jumps brought about by changes in temperature is expressed via characteristics of dislocation transformations to shortand long-lived barriers. The manner in which the thermally activated blocking of dislocation sources affects the magnitude of stress jumps in intermetallic compounds is investigated. Several alternative combinations of conditions are discussed, under which stressjumps similar to those observed in metals occur in intermetallic compounds with changing temperature.
منابع مشابه
Comparative Analysis of Stress Jumps in Metals and Intermetallic Compounds: ll. Stress Macrojumps
Following the scheme proposed in part I of this study, analysis of tWo-stagestraining in metals and intermetallic compounds is continued. Alternatives under which intermetalliccompounds can experience stress macrojumps, Le.. abnit»tincreases or decreases in stress upon a change in temperature are discussed. The likely connection between the occurrence of a macrojump. corresponding to an abrupt ...
متن کاملEffect of Fe additive on plastic deformation for crush-boxes with closed-cell metal foams, Part I: Al-composite foam compression response
AbstractIn this paper, we investigate effect of Fe–intermetallic compounds on plastic deformation of closed-cell composite Aluminum Foam as filler of thin-walled tubes. However, deformation of the Aluminum foam-filled thin-walled tubes as crushed-box will be presented in Part (II). Composite foams of AlSi7SiC3 and AlSi7SiC3-(Fe) as closed cell were synthesized by powder metallurgy foaming metho...
متن کاملImpact of Integration on Straining Modes and Shear-Locking for Plane Stress Finite Elements
Stiffness matrix of the four-node quadrilateral plane stress element is decomposed into normal and shear components. A computer program is developed to obtain the straining modes using adequate and reduced integration. Then a solution for the problem of mixing straining modes is found. Accuracy of the computer program is validated by a closed-form stiffness matrix, derived for the plane rectang...
متن کاملBimetal friction stir welding of aluminum to magnesium
FSW material flow and phase transformation were studied at the interface of dissimilar welding of Al 6013 to Mg. Defect free butt weld was obtained when aluminum and magnesium test plates were placed in the advancing side and retreating side respectively, and the tool was placed 1 mm off the weld centerline into the aluminum side. In order to understand how the materials flow during FSW, steel ...
متن کاملComparative study of nursing undergraduate education program in Universities of Iran and Widener University of USA
Introduction: To achieve successful nursing education system, solving health problems and promoting health, each country is committed to improving nursing education system. The comparison of different educational systems leads to content promotion and educational program. The purpose of this study was to compare the nursing undergraduate education program in Iran and university of Widener of US...
متن کامل