A Novel High-Performance Beam-Supported Membrane Structure with Enhanced Design Flexibility for Partial Discharge Detection
نویسندگان
چکیده
A novel beam-supported membrane (BSM) structure for the fiber optic extrinsic Fabry-Perot interferometer (EFPI) sensors showing an enhanced performance and an improved resistance to the temperature change was proposed for detecting partial discharges (PDs). The fundamental frequency, sensitivity, linear range, and flatness of the BSM structure were investigated by employing the finite element simulations. Compared with the intact membrane (IM) structure commonly used by EFPI sensors, BSM structure provides extra geometrical parameters to define the fundamental frequency when the diameter of the whole membrane and its thickness is determined, resulting in an enhanced design flexibility of the sensor structure. According to the simulation results, it is noted that BSM structure not only shows a much higher sensitivity (increased by almost four times for some cases), and a wider working range of fundamental frequency to choose, but also an improved linear range, making the system development much easier. In addition, BSM structure presents a better flatness than its IM counterpart, providing an increased signal-to-noise ratio (SNR). A further improvement of performance is thought to be possible with a step-forward structural optimization. The BSM structure shows a great potential to design the EFPI sensors, as well as others for detecting the acoustic signals.
منابع مشابه
A NOVEL FUZZY MULTI-OBJECTIVE ENHANCED TIME EVOLUTIONARY OPTIMIZATION FOR SPACE STRUCTURES
This research presents a novel design approach to achieve an optimal structure established upon multiple objective functions by simultaneous utilization of the Enhanced Time Evolutionary Optimization method and Fuzzy Logic (FLETEO). For this purpose, at first, modeling of the structure design problem in this space is performed using fuzzy logic concepts. Thus, a new problem creates with functio...
متن کاملDamage Detection of Axially Loaded Beam: A Frequency-Based Method
The present study utilizes an analytical method to formulate the three lowest modal frequencies of axially-loaded notched beam through both crack location and load level in a specific format that can be used in existing frequency-based crack-identification methods. The proposed formula provides a basis to shift into two states, one with axial loading and the other without any loading whatsoever...
متن کاملStructure Formation in Anode and Its Effect on the Performance of Micro-Tubular SOFC: A Brief Review
Anode-supported micro-tubular solid oxide fuel cell (SOFC) offers many advantages over the electrolyte and cathode-supported confgurations in terms of simplicity, reliability, and efciency. In such design, the anode substrates should possess a highly porous structure, provide active sites reaction as well as serving good mechanical strength. This structure is desired to ...
متن کاملCrack Detection of Fixed-Simply Supported Euler Bernoulli Beam Using Elman Networks
In this paper, the crack detection and depth ratio estimation method are presented in beamlikestructures using Elman Networks. For this purpose, by using the frequencies of modes asinput, crack depth ratio of each element was detected as output. Performance of the proposedmethod was evaluated by using three numerical scenarios of crack for fixed-simply supportedbeam consisting of a single crack...
متن کاملDesign of High Sensitivity and Linearity Microelectromechanical Systems Capacitive Tire Pressure Sensor using Stepped Membrane
This paper is focused on a novel design of stepped diaphragm for MEMS capacitive pressure sensor used in tire pressure monitoring system. The structure of sensor diaphragm plays a key role for determining the sensitivity of the sensor and the non-linearity of the output.First the structures of two capacitive pressure sensors with clamped square flatdiaphragms, with different thicknesses are inv...
متن کامل