Power System Load Frequency Control Using Combined Intelligent Techniques
نویسنده
چکیده
Advancing microprocessor technologies have brought automation capabilities to new levels of applications. Load frequency control of power systems (also called automatic generation control – AGC), is one of many important industrial application areas, which may greatly benefit from such advances. However, development and deployment of such applications are often difficult because of the complex dynamics of actual processes. Conventional control theory is based on mathematical models that describe the dynamic behavior of controlled systems. This is based on the deterministic nature of systems, but its applicability is reduced by computational complexity, parametric and structural uncertainABSTRACT
منابع مشابه
Load Frequency Control in Two Area Power System Using Sliding Mode Control
In this article, the sliding mode control of frequency load control of power systems is studied. The study areaconsists of a system of water and heat. First, a mathematical model of the proposed system disturbances ismade and then sliding control mode for frequency load control is provided. By the system simulation andsliding mode control, it can be shown that the damping of oscillations is wel...
متن کاملControl and stability improvement of combined wind-battery system with permanent magnet synchronous generator supplying active load
This paper deals with the control and stability enhancement of a wind power generation system feeding active load with constant power characteristic. The under study system is a combined wind-battery generation system with permanent magnet synchronous generator (PMSG) supplying active load by using interfaced power electronics converters. The employed active load is indeed an active rectifier b...
متن کاملLoad frequency control of two-area interconnected power system using fuzzy logic control approach
Power systems are composed of power units that are constantly connected to each other and the electric power flux is constantly moving between them. All systems must be implemented in such a way that not only under normal conditions but also unwanted inputs or disturbances, are applied. It also remains stable or returns to a stable name at the earliest possible time. The fundamental factors...
متن کاملOscillation Control of Aircraft Shock Absorber Subsystem Using Intelligent Active Performance and Optimized Classical Techniques Under Sine Wave Runway Excitation (TECHNICAL NOTE)
This paper describes third aircraft model with 2 degrees of freedom. The aim of this study is to develop a mathematical model for investigation of adoptable landing gear vibration behavior and to design Proportional Integration Derivative (PID) classical techniques for control of active hydraulic nonlinear actuator. The parameters of controller and suspension system are adjusted according to be...
متن کاملLoad Frequency Control in Power Systems Using Improved Particle Swarm Optimization Algorithm
The purpose of load frequency control is to reduce transient oscillation frequencies than its nominal valueand achieve zero steady-state error for it.A common technique used in real applications is to use theproportional integral controller (PI). But this controller has a longer settling time and a lot of Extramutation in output response of system so it required that the parameters be adjusted ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016