Average current control of DC-DC Cuk Converters as Power Factor Corrector
نویسندگان
چکیده
The era of electronic devices in all loads due to the manufacturing technologies replaced many conventional electrical or mechanical loads including lighting loads where Light Emitting Diodes (LEDs) is becoming an emerging technique with many advantages. High frequency switching dc-dc converter is a new technology to control the load and the supply side simultaneously. Due to additional harmonics generated by these switching converters power factor correction has become a necessity in utility side. This paper focuses on the power factor correction of the supply side when employing an ideal LED load with dc-dc Cuk converter. This paper also illustrates the controlling of the power factor correction employing high switching frequency dc-dc converters. The control loops employed are discussed and the strategy for designing the compensator is also explained. The simulated results have been shown to ascertain the accepted performance of the power factor correction converter. KeywordsCuk converter, Current control, DC-DC Converters, FFT Analysis, Light emitting diodes (LEDs), Power Factor Correction, Voltage Regulation
منابع مشابه
Closed Loop Control of Bridgeless Cuk Converter Using Fuzzy Logic Controller for PFC Applications
This paper is based on the bridgeless single-phase Ac– Dc Power Factor Correction (PFC) converters with Fuzzy Logic Controller. High frequency isolated Cuk converters are used as a modular dc-dc converter in Discontinuous Conduction Mode (DCM) of operation of Power Factor Correction. The aim of this paper is to simplify the program complexity of the controller by reducing the number of fuzzy se...
متن کاملA Repetitive Control- based Approach for Power Sharing among Boost Converters in DC Microgrids
In this paper a repetitive control (RC) approach to improve current sharing between parallel-connected boost converters in DC microgrids is presented. The impact of changes in line impedance on current sharing is investigated. A repetitive controller is designed and connected in series with current controller of the boost converters to control the switching signals such that by regulating of th...
متن کاملAn Intelligent Algorithm based Controller for Multiple Output DC-DC Converters with Voltage Mode Weighting Factor
Multiple output DC-DC converters are widely used in many applications such as aerospace, industrial and medical equipments. The purpose of this paper is to present an intelligent control system for the multiple output DC-DC converters. In order to perform this purpose, a double ended forward DC-DC converter with three output voltages (+5 V/ 50W, +15 V/ 45W and -15 V/ 15W) is considered and anal...
متن کاملAn Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation
In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...
متن کاملSVPWM Control based Bridgeless PFC Cuk Converter for PMSM under Dynamic Conditions
The widely used converter models in most of the power electronics and power system applications are the DC-DC converter models. Increase in switching losses has been observed in Conventional Diode Bridge Rectifier (DBR) and hence the researchers are more focused towards bridgeless converters. The design of a novel bridgeless cuk converter model with buck mode operation is focused in this work. ...
متن کامل