Determination of threshold exposure and intensity for recording holograms in thick green-sensitive acrylamide-based photopolymer.

نویسندگان

  • Mohammad Sultan Mahmud
  • Izabela Naydenova
  • Tzwetanka Babeva
  • Raghavendra Jallapuram
  • Suzanne Martin
  • Vincent Toal
چکیده

For optical data storage applications, it is essential to determine the lowest intensity (also known as threshold intensity) below or at which no data page or grating can be recorded in the photosensitive material, as this in turn determines the data capacity of the material. Here, experiments were carried out to determine the threshold intensity below which the formation of a simple hologram--a holographic diffraction grating in a green-sensitized acrylamide-based photopolymer--is not possible. Two main parameters of the recording layers--dye concentration and thickness--were varied to study the influence of the density of the generated free radicals on the holographic properties of these layers. It was observed that a minimum concentration per unit volume of free radicals is required for efficient cross-linking of the created polymer chains and for recording a hologram. The threshold intensity below which no hologram can be recorded in the Erythrosin B sensitized layers with absorbance less than 0.16 was 50 μW/cm(2). The real-time diffraction efficiency was analyzed in the early stage of recording. It was determined that the minimum intensity required to obtain diffraction efficiency of 1% was 90 μW/cm(2), and the minimum required exposure was 8 mJ/cm(2). It was also determined that there is an optimum dye concentration of 1.5 × 10(-7) mol/L for effective recording above which no increase in the sensitivity of the layers is observed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Optimization of a thick polyvinyl alcohol-acrylamide photopolymer for data storage using a combination of angular and peristrophic holographic multiplexing.

The capability of polyvinyl alcohol-acrylamide photopolymer materials to obtain angularly multiplexed holographic gratings has been demonstrated [Appl. Phys. B 76, 851 (2003)]. A combination of two multiplexing methods--peristrophic and angular multiplexing--is used to record 60 holograms. An exposure schedule method is used to optimize the capability of the photopolymerizable holographic mater...

متن کامل

Peristrophic multiplexed holograms recorded in a low toxicity photopolymer

Multiplexed diffraction gratings were recorded in 300 μm thick layers of biophotopol photopolymer by using two peristrophic multiplexing schemes separately and in combination. In addition, it was shown that riboflavin may be used as polymer initiator in acrylamide photopolymer films and the holographic properties of these films such as diffraction efficiency and dynamic range were compared with...

متن کامل

Volume polarization holographic recording in thick photopolymer for optical memory.

Based on a vector wave theory of volume holograms, dependence of holographic reconstruction on the polarization states of the writing and reading beams is discussed. It is found that under paraxial approximation the circular polarization holograms provide a better distinction of the reading beams. Characteristics of recording polarization holograms in thick phenanthrenequinone-doped poly(methyl...

متن کامل

Holographic recording in acrylamide photopolymers: thickness limitations.

Holographic recording in thick photopolymer layers is important for application in holographic data storage, volume holographic filters, and correlators. Here, we studied the characteristics of acrylamide-based photopolymer layers ranging in thickness from 250 microm to 1 mm. For each thickness, samples with three different values of absorbance were studied. By measuring the diffraction efficie...

متن کامل

Using acrylamide-based photopolymers for fabrication of holographic optical elements in solar energy applications.

A holographic device is under development that aims to improve light collection in solar cells. The aim is to explore the potential of using photopolymer holographic optical elements (HOEs) to collect light from a moving source, such as the sun, and redirect it for concentration by a holographic lens. A working range of 45° is targeted for such a device to be useful in solar applications withou...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Applied optics

دوره 49 28  شماره 

صفحات  -

تاریخ انتشار 2010