Not spreading in reverse: The dewetting of a liquid film into a single drop
نویسندگان
چکیده
Wetting and dewetting are both fundamental modes of motion of liquids on solid surfaces. They are critically important for processes in biology, chemistry, and engineering, such as drying, coating, and lubrication. However, recent progress in wetting, which has led to new fields such as superhydrophobicity and liquid marbles, has not been matched by dewetting. A significant problem has been the inability to study the model system of a uniform film dewetting from a nonwetting surface to a single macroscopic droplet-a barrier that does not exist for the reverse wetting process of a droplet spreading into a film. We report the dewetting of a dielectrophoresis-induced film into a single equilibrium droplet. The emergent picture of the full dewetting dynamics is of an initial regime, where a liquid rim recedes at constant speed and constant dynamic contact angle, followed by a relatively short exponential relaxation of a spherical cap shape. This sharply contrasts with the reverse wetting process, where a spreading droplet follows a smooth sequence of spherical cap shapes. Complementary numerical simulations and a hydrodynamic model reveal a local dewetting mechanism driven by the equilibrium contact angle, where contact line slip dominates the dewetting dynamics. Our conclusions can be used to understand a wide variety of processes involving liquid dewetting, such as drop rebound, condensation, and evaporation. In overcoming the barrier to studying single film-to-droplet dewetting, our results provide new approaches to fluid manipulation and uses of dewetting, such as inducing films of prescribed initial shapes and slip-controlled liquid retraction.
منابع مشابه
Liquid 4He on Cs : drying, depinning, and the non-wetting ‘thin-film’
Liquid 4He shows a dewetting phase on Cs and Rb at low temperatures. These are the only substrates which are not wetted by 4He. On Cs the wetting temperature, Tw, is about 2 K. Usually one observes a thick metastable helium film remaining on the Cs substrate when either the surface is cooled below Tw (so starting from a wet film) or when bulk helium (in the form of a drop or an advancing film) ...
متن کاملFilm cooling effectiveness in single row of holes: First moment closure modeling
The present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. The present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are ...
متن کاملInvestigation of Packing Effect on Mass Transfer Coefficient in a Single Drop Liquid Extraction Column
متن کامل
The shape of a liquid surface in a uniformly rotating cylinder in the presence of surface tension
The free-surface shape of a liquid in a uniformly rotating cylinder in the presence of surface tension is determined before and after the onset of dewetting at the bottom of the cylinder. Two scenarios of liquid withdrawal from the bottom are considered, with and without deposition of thin film behind the liquid. The governing non-linear differential equations for the axisymmetric liquid shapes...
متن کاملElectrowetting films on parallel line electrodes.
A lubrication analysis is presented for the spreading dynamics of a high permittivity polar dielectric liquid drop due to an electric field sustained by parallel line electrode pairs separated by a distance R(e). The normal Maxwell stress, concentrated at the tip region near the apparent three-phase contact line, produces a negative capillary pressure that is responsible for pulling out a thin ...
متن کامل