Carbon Aerogel-Supported Pt Catalysts for the Hydrogenolysis and Isomerization of n-Butane: Influence of the Carbonization Temperature of the Support and Pt Particle Size

نویسندگان

  • Carlos Moreno-Castilla
  • Marta B. Dawidziuk
چکیده

Carbon aerogels prepared at different carbonization temperatures and with varying mesopore volumes were used as supports for Pt catalysts to study the n-C4H10/H2 reaction. Mean Pt particle size depended on the mesopore volume of the support, showing a linear decrease when the mesopore volume increased. The turnover frequency (TOF) for hydrogenolysis was much higher than for isomerization in catalysts supported on carbon aerogels obtained at 900–950 °C. However, both TOF values were similar in catalysts supported on the carbon aerogel obtained at 500 °C. TOF for hydrogenolysis and isomerization were related to the mean Pt particle size in catalysts supported on carbon aerogels obtained at 900–950 °C. In addition, both reactions showed a compensation effect between the activation energy and pre-exponential factor, indicating that they have the same intermediate, i.e., the chemisorbed dehydrogenated alkane.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

CATALYTIC REFORMING OF n-HEPTANE ON PLATINUM-TUNGSTEN SUPPORTED ON GAMMA-ALUMINA

The mono-metallic and bi-metallic catalysts have been prepared by impregnating with solutions containing a compound of H2PtCl6,WO3 and 1ml HCl (0.1 mol). It should be noted that the catalysts’ activity and selectivity have been determined under these conditions : 450-5000C ,and 15-25atm by H2. For converting n-heptane , the molar ratio H2/C7H16 is 5 , and LHSV is 1.5ml/h. It has been proved tha...

متن کامل

Conversion of N-Heptane on Pt/Al2O3 Catalyst

Hydrogenation reaction with n-heptane on Pt/Al2O3 catalyst was investigated under the steady state condition in a fixed bed reactor. The catalyst was prepared under a variety of conditions, but the one chosen was non-acidic that is not considered a hydrocracking catalyst. The main objective was to vary the selectivity of n-heptane as a function of reaction variables es...

متن کامل

CATALYTIC REFORMING OF n-HEPTANE ON PLATINUMNIOBIUM SUPPORTED ON GAMMA-ALUMINA

The series of mono-metallic and bi-metallic catalysts have been prepared by impregnatingwith solutions containing compound of H2PtC15,NbC15 and lml HC1 (0.1 mol). The activityand selectivity of the catalysts have been determined under conditions at 450-500°C, 15-30atm. Molar ratio H2/C7H16=5 and VVH=1.5/h for converting n-heptane. Under theseexperimental conditions it has been established that ...

متن کامل

Hydroisomerization of n-Pentane over Pt/Mordenite Catalyst: Effect of Feed Composition and Process Conditions

The hydroisomerization of pure n-pentane over H-mordenite supported Pt-catalyst was investigated in a fixed bed reactor by changing reaction parameters such as temperature, pressure, and WHSV, as well as the H2/HC ratio. The maximum yield of isopentane over Pt/mordenite catalyst was achieved at 220 °C and a relatively low reaction pressure. To address the effect of feed composition on the catal...

متن کامل

Thermal regeneration and decoking optimization of chlorinated platinum/alumina catalysts for the isomerization process

The samples of spent chlorinated Pt/Al2O3 catalysts that were used in the isomerization process were decoked at elevated temperatures under airflow and different oxygen concentrations. The surface of the catalyst was characterized by thermal gravimetric analysis, differential scanning calorimetry, Brunauer-Emmett-Teller analysis, attenuated total reflection fast Fourier in...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012