Nanorods on surface of GaN-based thin-film LEDs deposited by post-annealing after photo-assisted chemical etching
نویسندگان
چکیده
This study investigates the optoelectronic characteristics of gallium nitride (GaN)-based thin-film light-emitting diodes (TF-LEDs) that are formed by a two-step transfer process that involves wet etching and post-annealing. In the two-step transfer process, GaN LEDs were stripped from sapphire substrates by the laser lift-off (LLO) method using a KrF laser and then transferred onto ceramic substrates. Ga-K nanorods were formed on the surface of the GaN-based TF-LEDs following photo-assisted chemical etching and photo-enhanced post-annealing at 100 °C for 1 min. As a result, the light output power of GaN-based TF-LEDs with wet etching and post-annealing was over 72% more than that of LEDs that did not undergo these treatments.
منابع مشابه
Structural Properties of Post Annealed ITO Thin Films at Different Temperatures
Indium tin oxide (ITO) thin films were deposited on glass substrates by RF sputtering using an ITO ceramic target (In2O3-SnO2, 90-10 wt. %). After deposition, samples were annealed at different temperatures in vacuum furnace. The post vacuum annealing effects on the structural, optical and electrical properties of ITO films were investigated. Polycrystalline...
متن کاملNano-structural Characterization of Post-annealed ZnO Thin Films by X-ray Diffraction and Field Emission Scanning Electron Microscopy
ZnO thin films were deposited on Si(400) substrates by e-beam evaporation technique, and then post-annealed at different annealing temperatures (200-800°C). Dependence of the crystallographic structure, nano-strain, chemical composition and surface physical Morphology of these layers on annealing temperature were studied. The crystallographic structure of films was studied using X-Ray Diffracti...
متن کاملNano-structural Characterization of Post-annealed ZnO Thin Films by X-ray Diffraction and Field Emission Scanning Electron Microscopy
ZnO thin films were deposited on Si(400) substrates by e-beam evaporation technique, and then post-annealed at different annealing temperatures (200-800°C). Dependence of the crystallographic structure, nano-strain, chemical composition and surface physical Morphology of these layers on annealing temperature were studied. The crystallographic structure of films was studied using X-Ray Diffracti...
متن کاملPb-Free High Temperature Solder Joints for Power Semiconductor Devices
Three types of inexpensive Pb-free solder joints, namely Zn-based and Bi-based solders, and a CuSn alloy were studied for application to the high-temperature operation of wide band-gap power semiconductor devices using GaN or SiC. Zn– Al solder sheets, whose melting point is 380°C were prepared, and then surface oxides were removed by RF plasma etching. Subsequently, Cu thin films were deposite...
متن کاملEffect of sulfur hexafluoride gas and post-annealing treatment for inductively coupled plasma etched barium titanate thin films
Aerosol deposition- (AD) derived barium titanate (BTO) micropatterns are etched via SF6/O2/Ar plasmas using inductively coupled plasma (ICP) etching technology. The reaction mechanisms of the sulfur hexafluoride on BTO thin films and the effects of annealing treatment are verified through X-ray photoelectron spectroscopy (XPS) analysis, which confirms the accumulation of reaction products on th...
متن کامل