Block Bundle Adjustment of Landsat 7 ETM+ Images over Mountainous Areas

This research study showed the potential of block bundle adjustment with nadir viewing sensor images, such as Landsat 7 ETM . The method is based on the 3D analytical geometric model developed for multisensor images at the Canada Centre for Remote Sensing, Natural Resources Canada. Different block sizes and configurations were tested and compared using an image bundle adjustment. The different tests using 15 Landsat 7 ETM images (five paths and three rows) acquired over a study site in the Canadian Rocky Mountains, showed that the same results (around 25-m errors) could be obtained with image blocks as with a single image using a largely reduced number of ground control points (GCPs). However, the combined image measurement and map errors of GCPs were included in the final error budget, and the internal accuracy of the blocks should be better (around one pixel or less). The number of GCPs to be used depended mainly on the cartographic data accuracy: more GCPs than the minimum required reduced the error propagation in the least-squares block bundle adjustment. In addition, tie points with a known elevation value (elevation tie points, ETPs) instead of normal tie points were used to link the adjacent images/strips (northsouth and east-west) because the viewing-angle differences of overlapping images were smaller than 1° in north-south overlaps and around 10° in east-west overlaps. Better and more consistent results were also obtained using strips of images in the blocks acquired from the same orbit and date instead of using independent images. Finally, using only GCPs in the outer strips/images and ETPs in each overlap achieved the same results (25-m errors). Introduction As in photogrammetry where strips and blocks of aerial photos are processed together when no or few ground data are available, the same process can be applied with satellite images from the same and/or adjacent orbits, thus performing the geometric processing with a block bundle adjustment instead of a single image bundle adjustment. There are different advantages to the block bundle adjustment: • The number of ground control points (GCPs) is largely reduced; • All image geometric models are computed together; • A homogeneous digital elevation model (DEM) can be generated when the block has a full and good stereo coverage; • A better relative accuracy between the images can be obtained; • A more homogeneous and accurate ortho-mosaic over large areas can be obtained; and • A homogeneous GCP network for geometric processing can be generated. Block Bundle Adjustment of Landsat 7 ETM Images over Mountainous Areas