Tensile Behavior of Single-Crystal Tin Whiskers

نویسندگان

  • S. S. SINGH
  • R. SARKAR
  • H.-X. XIE
  • C. MAYER
  • J. RAJAGOPALAN
  • N. CHAWLA
چکیده

The growth of metallic (predominantly Sn) whiskers from pure metallic platings has been studied for over 50 years. While the phenomenon of Sn whiskering has been studied for decades, very little is known about the mechanical properties of these materials. This can be attributed to the difficulty in handling, gripping, and testing such fine-diameter and high-aspect-ratio whiskers. We report on the stress–strain behavior of Sn whiskers inside a dual-beam focused ion beam (FIB) with a scanning electron microscope (SEM). Lift-out of the whiskers was conducted in situ in the FIB, and the whiskers were tested using a microelectromechanical system tensile testing stage. Using this technique, the whiskers had minimum exposure to ambient air and were not handled by hand. SEM images after fracture enabled reliable calculation of the whisker cross-sectional area. Tests on two different whiskers revealed relatively high tensile strengths of 720 MPa and 880 MPa, respectively, and a limited strain to failure of 2% to 3%. For both whiskers, the Young’s modulus was between 42 GPa and 45 GPa. It is interesting to note that the whiskers were quite strong and had limited ductility. These findings are intriguing and provide a basis for further work to understand the effect of Sn whisker mechanical properties on short circuits in electronics.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

In situ tensile testing of tin (Sn) whiskers in a focused ion beam (FIB)/scanning electron microscope (SEM)

Article history: Received 22 May 2017 Received in revised form 7 July 2017 Accepted 8 July 2017 Available online 19 July 2017 Tin and tin-alloyed electroplated films are known to be susceptible to whisker growth under a range of conditions,manyofwhich result in the generation of compressive stresses in thefilm. Compressive stress is considered to be one of the primary causes for whisker nucleat...

متن کامل

Internal Microstructure Investigation of Tin Whisker Growth Using FIB Technology

The problem of tin (Sn) whiskers has been a significant reliability issue in electronics for the past several decades. Despite the large amount of research conducted on this issue, a solution for mitigating the growth of whiskers remains a challenge for the research community. Whiskers have unpredictable growth and morphology, and a study of a whisker’s internal structure may provide further in...

متن کامل

Tin Whiskers Remain A Concern

The elimination of lead in electronic equipment due to governmental regulations (European Union End of Life Vehicle Directive and European Union Restriction of Hazardous Substances Directive) has increased the risk of electrical shorting due to the formation of tin whiskers in electronic products. Tin whiskers are hair-like tin structures that grow sporadically on surfaces coated with tin. Whis...

متن کامل

Grain Refinement Efficiency of Multi-Axial Incremental Forging and Shearing: A Crystal Plasticity Analysis

Severe plastic deformation is a technical method to produce functional material with special properties such as high strength and specific physical properties. Selection of an efficient severe plastic deformation for grain refinement is a challenging field of study and using a modeling technique to predict the refinement efficiency has gained a lot of attentions. A comparative study was carried...

متن کامل

Mechanical Characteristics and Failure Mechanism of Nano-Single Crystal Aluminum Based on Molecular Dynamics Simulations: Strain Rate and Temperature Effects

Besides experimental methods, numerical simulations bring benefits and great opportunities to characterize and predict mechanical behaviors of materials especially at nanoscale. In this study, a nano-single crystal aluminum (Al) as a typical face centered cubic (FCC) metal was modeled based on molecular dynamics (MD) method and by applying tensile and compressive strain loadings its mechanical ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014