Radio specifications of double conversion tuner for cable modem
نویسندگان
چکیده
The radio specifications such as noise figure, phase noise, image rejection ratio, CTB, CSO, XMOD, power gain, and AGC range of the tuner for cable modem is analyzed based on DOCSIS and many reported materials. Using the analyzed radio specifications, the specific radio specifications are allocated for up and down converter of the DC tuner architecture and analyzed CTB and CSO requirement in depth. According to the linearity analysis for the DC tuner architecture, it is known that CTB and CSO value of -53dBc, which is commonly accepted by the field engineer, is over-specified. By the more reasonable selection of linearity target, it is possible to design DC tuner with better power efficiency. Index Terms — Radio Specifications, Cable Modem, DOCSIS, CTB, CSO
منابع مشابه
Hybrid Fiber Radio Link for Feeding DOCSIS Wireline and Wireless Heterogeneous Access
We demonstrate the successful transmission of Data Over Cable Service Interface Specification (DOCSIS) signals in the 600 MHz and 5.5 GHz frequency bands. Both signals are generated simultaneously using an optical harmonic up-conversion of the DOCSIS signal provided by a cable modem termination system (CMTS). The optical signal is transmitted over 10 km SSMF. After photo-detection, the wireline...
متن کاملEffects of the Distinction between Long and Short Data Grants in DOCSIS Network
In this paper, we analyze the effects of the distinction between long and short data grants in the Data Over Cable Service Interface specifications (DOCSIS) protocol. According to DOCSIS specifications, the grants for a bandwidth request of a cable modem can be for either short or long data packets. The threshold value classifying a short and long data packet is a system operation parameter and...
متن کاملRfc 4323 Ipcdn
This document defines a basic set of managed objects for SNMP-based management of extended QoS features of Cable Modems (CMs) and Cable Modem Termination Systems (CMTSs) conforming to the Data over Cable System (DOCSIS) specifications versions 1.1 and 2.0. Patrick & Murwin Standards Track [Page 1] RFC 4323 IPCDN DOCSIS QoS MIB January 2006
متن کاملA Completely Integrated Low Jitter CMOS PLL for Analog Front Ends in System on Chip Environment
This paper describes the PLL designed for the analog front-end of the silicon tuner in the cable modem system. The PLL is used to generate clocks (150-175MHz) for the DAC and hence the phase noise (jitter) requirement is very aggressive (15ps rms, which is less than 1 degree of integrated phase error). Low noise design for all the main blocks was a key to achieve this. Care was taken to reduce ...
متن کاملActive Queue Management (AQM) Based on Proportional Integral Controller Enhanced PIE) for Data-Over-Cable Service Interface Specifications (DOCSIS) Cable Modems
Cable modems based on Data-Over-Cable Service Interface Specifications (DOCSIS) provide broadband Internet access to over one hundred million users worldwide. In some cases, the cable modem connection is the bottleneck (lowest speed) link between the customer and the Internet. As a result, the impact of buffering and bufferbloat in the cable modem can have a significant effect on user experienc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IEEE Trans. Consumer Electronics
دوره 49 شماره
صفحات -
تاریخ انتشار 2003