Resonant-Boost-Input Three-Phase Power Factor Corrector
نویسنده
چکیده
This paper presents a novel three-phase power factor corrector (PFC) circuit which uses two power switches working in zero-voltage-switching (ZVS) condition. The two switches along with a high-frequency inductor constitute a high-frequency current source which is responsible for the energy transfer in the circuit. The input current is partly continuous and partly discontinuous. The total harmonic distortion (THD) in the input current has a low value of 4.5%, and the output dc voltage is very close to the peak line voltage. The operation of the converter is explained by identifying the different switching modes, and the simulation and experimental waveforms are presented.
منابع مشابه
Design of Quasi Resonant Boost Converter Using Zero Current Switching With Push Pull Technology
In this project reduced switching losses and high efficiency is proposed for quasi resonant converter. An AC/DC quasi resonant converter with push pull topology is coupled to two distributed boost inductors into a single magnetic core which hereby reducing the circuit volume and the cost are the development targets of switching power supply today. The quasi resonant converter has ideally zero s...
متن کاملA Single Transistor Three Phase Resonant Switch for High Quality Rectification
Existing 34, ac-dc low-harmonic rectiifiers are costly and require complex control schemes to minimize input current harmonics. Introduced here are three new classes of low cost 34, acdc high power factorllow harmonic controlled rectifiers. These are derived from parent dc-dc convrter topologies containing boost-type inputs, buck-type inputs and qwsi resonant zero-current-switch (ZCS) buck-type...
متن کاملA Comparative Study of Single-switch, Three-phase, High-power-factor Rectifiers
Three three-phase, single-switch, high-powerfactor rectifier implementations were evaluated on a comparative basis. Specifically, the discontinuousconduction-mode boost rectifier with a 5-harmonic-trap filter, the discontinuous-conduction-mode boost rectifier with a harmonic-injection circuit, and the multi-resonant, zero-current-switching buck rectifier were compared with respect to their effi...
متن کاملPower factor correction circuit for low-cost electronic ballast using current-source type
Introduction. With the adoption of standards such as IEC555-2, there is a need to develop electronic ballasts for fluorescent lamps which can perform line current harmonic reduction and high input power factor correction (PFC). Among various filtering techniques, the active power factor corrector with a tioost converter has, been proven to be effective [l 31. The boost-type PFC circuit is one o...
متن کاملThree Phase Three Level Unidirectional PWM Rectifier
Almost two decades of research on unidirectional three-phase multilevel boost-type pulse width modulation (PWM) rectifiers have shown the benefits of employing this technology to comply with power quality standards while assuring high efficiency and low volume and weight. However, the unidirectional topologies directly derived from the conventional three-level bidirectional converters, such as ...
متن کامل