Timing Stabilization for the Slc Electron
نویسندگان
چکیده
The timing stability required for the SLC electron source is determined by the energy acceptance of the electron damping ring. The jitter requirements for the gun pulse itself are somewhat mitigated by the subsequent bunching process. The design of the system by which a gun pulse stability of u 20 ps is achieved is described, and experiments,to measure the resulting energy stability under various bunching conditions are discussed.
منابع مشابه
Fast Feedback for Linear Colliders
A fast feedback system provides beam stabilization for the SLC. As the SLC is in some sense a prototype for future linear colliders, this system may be a prototype for future feedbacks. The SLC provides a good base of experience for feedback requirements and capabilities as well as a testing ground for performance characteristics. The feedback system controls a wide variety of machine parameter...
متن کاملTiming Jitter Measurements at the Slc Electron Source’
The SLC thermionic gun and electron source produce a beam of up to 15 x 10” ein a single S-band bunch. A 170 keV, 2 ns FWHM pulse out of the gun is compressed by means of two subharmonic buncher cavities followed by an S-band buncher and a standard SLAC accelerating section. Ceramic gaps in the beam pipe at the output of the gun allow a measure of the beam intensity and timing. A measurement at...
متن کاملThree Bunch Energy Stabilization for the Slc Injector*
Slow feedback has been developed to control the energy and energy spread of the beams which are injected into the SLC dqping rings. Within a single RF pulse, two bunches of electrons and one bunch of positrons are accelerated to an energy of 1.21 GeV in the injector of the SLC. The two electron bunches are deflected into the north damping ring while the positrons are targeted into the south rin...
متن کاملPEP-II Injection Timing and Controls
Hardware has been built and software written and incorporated in the existing SLC accelerator control system to control injection of beam pulses from the accelerator into the PEP-II storage rings currently under construction. Hardware includes a CAMAC module to delay the machine timing fiducial in order that a beam pulse extracted from a damping ring will be injected into a selected group of fo...
متن کاملThe Effect of Six-Legged Concrete Elements on Hydraulic Jump Characteristics
In the present study, the six legged concrete (SLC) elements are placed at the bed of a flume downstream of a chute in different layouts, densities and number of longitudinal rows of SLC elements. Each test was run for different flow conditions (Froude numbers ranged 5.3 to 8.1). During each test, the water surface profile, the roller length and the jump length measured. Applying the experimen...
متن کامل