Transient thermal dissipation method of xylem sap flow measurement: multi-species calibration and field evaluation.

نویسندگان

  • S Isarangkool Na Ayutthaya
  • F C Do
  • K Pannengpetch
  • J Junjittakarn
  • J-L Maeght
  • A Rocheteau
  • H Cochard
چکیده

The transient thermal dissipation (TTD) method developed by Do and Rocheteau (2002b) is a close evolution of the original constant thermal dissipation (CTD) method of Granier (1985). The TTD method has the advantage of limiting the influence of passive natural temperature gradients and of yielding more stable zero-flux references at night. By analogy with the CTD method, the transient method was first calibrated on synthetic porous material (sawdust) on the assumption that the relationship was independent of the woody species. Here, our concern was to test the latter hypothesis with a 10-min heating time in three tropical species: Hevea brasiliensis Müll. Arg., Mangifera indica L. and Citrus maxima Merr. A complementary objective was to compare the field estimates of daily transpiration for mature rubber trees with estimates based on a simplified soil water balance in the dry season. The calibration experiments were carried out in the laboratory on cut stems using an HPFM device and gravimetric control of water flow up to 5 L dm(-2) h(-1). Nineteen response curves were assessed on fully conductive xylem, combining 11 cut stems and two probes. The field evaluation comprised five periods from November 2007 to February 2008. Estimates of daily transpiration from the measurement of sap flow were based on the 41 sensors set up on 11 trees. Soil water depletion was monitored by neutron probe and 12 access tubes to a depth of 1.8 m. The calibrations confirmed that the response of the transient thermal index to flow density was independent of the woody species that were tested. The best fit was a simple linear response (R(2) = 0.88, n = 276 and P < 0.0001). The previous calibration performed by Do and Rocheteau (2002b) on sawdust fell within the variability of the multi-species calibration; however, there were substantial differences with the average curve at extreme flow rates. Field comparison with soil water depletion in the dry season validated to a reasonable extent the absolute estimates of transpiration acquired with the 10-min TTD method. In conclusion, evidence for the independence of calibration from woody species and the simple linear response of the thermal index strengthen the interest of the TTD method with 10-min heating.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Transient thermal dissipation method for xylem sap flow measurement: implementation with a single probe.

Comparisons of tree water relations between treatments, species and sites are facilitated by the use of simple and low-cost measurements of xylem sap flow rates. The transient thermal dissipation (TTD) method is a variant of the constant thermal dissipation (CTD) method of Granier. It has the advantages of limiting thermal interference and of saving electrical energy. Here, our concern was to t...

متن کامل

Calibration of thermal dissipation sap flow probes for ring- and diffuse-porous trees.

Thermal dissipation probes (the Granier method) are routinely used in forest ecology and water balance studies to estimate whole-tree transpiration. This method utilizes an empirically derived equation to measure sap flux density, which has been reported as independent of wood characteristics. However, errors in calculated sap flux density may occur when large gradients in sap velocity occur al...

متن کامل

An alternative method to estimate zero flow temperature differences for Granier's thermal dissipation technique.

Calibration of the Granier thermal dissipation technique for measuring stem sap flow in trees requires determination of the temperature difference (DeltaT) between a heated and an unheated probe when sap flow is zero (DeltaT(max)). Classically, DeltaT(max) has been estimated from the maximum predawn DeltaT, assuming that sap flow is negligible at nighttime. However, because sap flow may continu...

متن کامل

Calibration of sap flow estimated by the compensation heat pulse method in olive, plum and orange trees: relationships with xylem anatomy.

The compensation heat pulse method is widely used to estimate sap flow in conducting organs of woody plants. Being an invasive technique, calibration is crucial to derive correction factors for accurately estimating the sap flow value from the measured heat pulse velocity. We compared the results of excision and perfusion calibration experiments made with mature olive (Olea europaea L. 'Manzani...

متن کامل

Assessing the thermal dissipation sap flux density method for monitoring cold season water transport in seasonally snow-covered forests.

Productivity of conifers in seasonally snow-covered forests is high before and during snowmelt when environmental conditions are optimal for photosynthesis. Climate change is altering the timing of spring in many locations, and changes in the date of transition from winter dormancy can have large impacts on annual productivity. Sap flow methods provide a promising approach to monitor tree activ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Tree physiology

دوره 30 1  شماره 

صفحات  -

تاریخ انتشار 2010