SURFACE SCIENCE LETTERS 54-0 BOND FORMATION ON THE Si(lOO)-2 x 1 SURFACE AT THE EARLY STAGE OF OXIDATION AS OBSERVED BY AES
نویسنده
چکیده
Auger electron spectroscopy is used to follow the initial chemisorption of oxygen on a Si(lOO)-2 x 1 surface. Careful measurements of the Si L,sVV spectra reveal, for the first time, fine structure in the region between 80 and 85 eV. For the clean Si(100) surface a peak at 81 eV has been found. Oxygen chemisorption on the Si(100) surface is associated with the appearance of a new well defined peak at 83 eV in addition to the peak at 81 eV. Since these features are discernible for the (100) crystal face, the 83 eV transition is assigned as due to the Si-0 bond.
منابع مشابه
Effect of Surface Morphologies on the Isothermal Oxidation Behavior of MCrAlY Coatings Fabricated by High-velocity Oxyfuel Processes
In this study, the effect of surface morphologies on the isothermal oxidation behavior of MCrAlY coatings fabricated by high-velocity oxyfuel (HVOF) processes was investigated. To do so, free standing coatings with as-sprayed and polished surfaces were isothermally oxidized at 1050°C. The thickness of the bond coat was approximately 380μm. The Ra of the as-sprayed and polished surfaces were 6.4...
متن کاملFormation and Evaluation of Oxidation Behavior of Zirconia- Aluminide Coating on Nickel- Based Alloy
Practical applications of thermal barrier coatings with aluminide bond-coats are limited due to oxide scale spallation of the aluminide coating under applied thermal stresses. Considering the positive effects of oxygen-active elements or their oxides on the high temperature oxidation behavior, in this research zirconia was introduced into an aluminide coating. For this purpose, a Watts type bat...
متن کاملEffect of Si on the oxidation reaction of α-Ti(0 0 0 1) surface: ab initio molecular dynamics study
We present our ab initio molecular dynamics (MD) study of the effect of Si on the oxidation of α-Ti(0 0 0 1) surfaces. We varied the Si concentration in the first layer of the surface from 0 to 25 at.% and the oxygen coverage (θ) on the surface was varied up to 1 monolayer (ML). The MD was performed at 300, 600 and 973 K. For θ = 0.5 ML, oxygen penetration into the slab was not observed after 1...
متن کاملIn situ ESR observation of interface dangling bond formation processes during ultrathin SiO2 growth on Si(111).
We report the formation processes of interface dangling bonds (Pb centers) during initial oxidation of a clean Si(111) surface using an ultrahigh-vacuum electron-spin-resonance technique. At the oxidation of one or two Si layer(s), the Pb center density reached around 2.5-3.0 x 10(12) cm(-2), which is the same density as in the case of thick SiO2. This result shows that the Pb center density do...
متن کاملEFFECT OF COMPOSITION ON PHASE EVOLUTION AND MICROSTRUCTURE OF REACTION BONDED MULLITE (RBM)
Compositions of Al2O3+Si, SiO2+Al and Al+Si systems were prepared to study the effect of reaction bonding process on the mullite formation. The composition of each system was adopted according to mullite stoichiometery and sintered in 700-1600°C range. Results showed that the formation of reaction bonded mullite starting from Al2O3+Si mixtures, proceeded in two partially overlapping steps, the ...
متن کامل