Development of Trigger and Control Systems for CMS

During the year of 2007, the Large Hadron Collider (LHC) and its four main detectors will begin operation with a view to answering the most pressing questions in particle physics. However before one can analyse the data produced to find the rare phenomena being looked for, both the detector and readout electronics must be thoroughly tested to ensure that the system will operate in a consistent way. The Compact Muon Solenoid (CMS) is one of the two general-purpose detectors at CERN. The tracking component of the design produces more data than any previous detector used in particle physics, with approximately ten million detector channels. The data from the detector is processed by the tracker Front End Driver (FED). The large data volume necessitated the development of a buffering and throttling system to prevent buffer overflow both on and off the detector. A critical component of this system is the APV emulator (APVe), which vetoes trigger decisions based on buffer status in the tracker. The commissioning of these components, along with a large part of the Timing, Trigger and Control (TTC) system is discussed, including the various modifications that were made to improve the robustness of the full system. Another key piece of the CMS electronics is the calorimeter trigger system, responsible for identifying ‘interesting’ physical events in a background of well-understood phenomena using calorimetric information. Calorimeter information is processed to identify various trigger objects by the Global Calorimeter Trigger (GCT). The first component of this system is the Source card, which has been developed to transfer data from the Regional Calorimeter Trigger (RCT) to the Leaf card, the processing engine of the GCT. The use of modern programmable logic with high speed optical links is discussed, emphasising its use for data concentration and the benefit it confers to the processing algorithms. Looking forward to Super-LHC, a possible addition to the CMS Level-1 trigger system is discussed, incorporating information from a new pixel detector with an alternative stacked geometry that allows the possibility of on-detector data rate reduction by means of a transverse momentum cut. A toy Monte Carlo was developed to study detector performance. Issues with high-speed reconstruction and the complications of on-detector data rate reduction are also discussed.