Bulk quantities of single-crystal silicon micro-/nanoribbons generated from bulk wafers.

نویسندگان

  • Heung Cho Ko
  • Alfred J Baca
  • John A Rogers
چکیده

This Letter demonstrates a strategy for producing bulk quantities of high quality, dimensionally uniform single-crystal silicon micro- and nanoribbons from bulk silicon (111) wafers. The process uses etched trenches with controlled rippled structures defined on the sidewalls, together with angled evaporation of masking materials and anisotropic wet etching of the silicon, to produce multilayer stacks of ribbons with uniform thicknesses and lithographically defined lengths and widths, across the entire surface of the wafer. Ribbons with thicknesses between tens and hundreds of nanometers, widths in the micrometer range, and lengths of up to several centimeters, can be produced, in bulk quantities, using this approach. Printing processes enable the layer by layer transfer of organized arrays of such ribbons to a range of other substrates. Good electrical properties (mobilities approximately 190 cm(2)V(-1)s(-1), on/off >10(4)) can be achieved with these ribbons in thin film type transistors formed on plastic substrates, thereby demonstrating one potential area of application.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Printable Single-Crystal Silicon Micro/Nanoscale Ribbons, Platelets and Bars Generated from Bulk Wafers

Printable or solution processable semiconductor materials have attracted significant attention recently due to their potential to enable cost effective, non-vacuum based fabrication approaches for large area electronics, often referred to as macroelectronics, and particularly to systems that use low cost plastic substrates. Several classes of semiconducting small molecule and polymer materials ...

متن کامل

One-dimensional single-crystalline bismuth oxide micro/nanoribbons: morphology-controlled synthesis and luminescent properties.

Based on a facile vapor-phase transport method without any catalyst and template, one-dimensional single-crystalline bismuth oxide (Bi2O3) micro/nanoribbons were fabricated on silicon substrates in large quantities and morphology-controlled fabrication of Bi2O3 was achieved from a single precursor. The widths of Bi2O3 ribbons varied from 0.2 to 20 microm depending on the deposition temperatures...

متن کامل

Temperature - Dependent Thermal Conductivity of Single - Crystal Silicon Layers in SOI Substrates

Self heating diminishes the reliability of silicon-on-insulator (SOI) transistors, particularly those that must withstand electrostatic discharge (ESD) pulses. This problem is alleviated by lateral thermal conduction in the silicon device layer, whose thermal conductivity is not known. The present work develops a technique for measuring this property and provides data for layers in wafers fabri...

متن کامل

Applications of the Quasi - Steady - State Photoconductance Technique

The main applications of photoconductance measurements of silicon wafers are the determination of implicit device voltages, bulk minority carrier lifetimes, emitter recombination currents and surface recombination velocities. These applications are illustrated with selected experiments. Multicrystalline and single crystal silicon wafers are used with different surface conditions. The practical ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Nano letters

دوره 6 10  شماره 

صفحات  -

تاریخ انتشار 2006