Encoders and Fault Detection
نویسنده
چکیده
Monitoring large-scale systems is of fundamental importance in modern infrastructures. Many of these large-scale systems are complex interconnections of sub-components which interact by means of communication channels with limited bandwidth. Therefore the information must be encoded in order to be transmitted. Given a class of encoders, the problem of detecting faults affecting some of these sub-components starting from the encoded information is studied, and a precise characterization of a class of faults which can be detected is given.
منابع مشابه
Concurrent Fault Detection for Orthogonal Latin Quadrangle Encoders and Condition Computation
fault correction codes (FCCs) are usually used to defend recollections aligned with responsibility. amongst FCCs, orthogonal Latin quadrangle (OLQ) policy have increase transformed concentration for reminiscence SFCurity due to their modularity and the straightforwardness of the decipher algorithm that facilitate low holdup implementations. An important concern is that as FCCs is used, the enco...
متن کاملAn Efficient Design of Vlsi Architecture for Fault Detection Using Orthogonal Latin Squares (ols) Codes
Error correction codes (ECCs) are commonly used to protect memories against errors. Among ECCs, orthogonal latin squares (OLS) codes have gained renewed interest for memory protection due to their modularity and the simplicity of the decoding algorithm that enables low delay implementations. An important issue is that when ECCs are used, the encoder and decoder circuits can also suffer errors. ...
متن کاملAn Unknown Input Observer for Fault Detection Based on Sliding Mode Observer in Electrical Steering Assist Systems
Steering assist system controls the force transfer behavior of the steering system and improves the steering probability of the vehicle. Moreover, it is an interface between the diver and vehicle. Fault detection in electrical assisted steering systems is a challenging problem due to frequently use of these systems. This paper addresses the fault detection and reconstruction in automotive elect...
متن کاملSupport for Fault Tolerance in Vlsi Processors †
Fault tolerance techniques are used to allow computer systems to continue correct operation despite component failure. Hardware-supported concurrent error-detection and limited fault tolerance in system components, as implemented by coding or replication, are often required. Detection latency can be reduced by increasing the visibility of internal module state using compressed ‘‘signatures’’ of...
متن کاملApplication of Thau Observer for Fault Detection of Micro Parallel Plate Capacitor Subjected to Nonlinear Electrostatic Force
This paper investigates the fault detection of a micro parallel plate capacitor subjected to nonlinear electrostatic force. For this end Thau observer, which has good ability in fault detection of nonlinear system has been presented and governing nonlinear dynamic equation of the capacitor has been presented. Upper and lower threshold for fault detection have been obtained. The robustness of th...
متن کامل