Three dimensional characterization of GaN-based light emitting diode grown on patterned sapphire substrate by confocal Raman and photoluminescence spectromicroscopy
نویسندگان
چکیده
We performed depth-resolved PL and Raman spectral mappings of a GaN-based LED structure grown on a patterned sapphire substrate (PSS). Our results showed that the Raman mapping in the PSS-GaN heterointerface and the PL mapping in the InxGa1-xN/GaN MQWs active layer are spatially correlated. Based on the 3D construction of E2(high) Raman peak intensity and frequency shift, V-shaped pits in the MQWs can be traced down to the dislocations originated in the cone tip area of PSS. Detail analysis of the PL peak distribution further revealed that the indium composition in the MQWs is related to the residual strain propagating from the PSS-GaN heterointerface toward the LED surface. Numerical simulation based on the indium composition distribution also led to a radiative recombination rate distribution that shows agreement with the experimental PL intensity distribution in the InxGa1-xN/GaN MQWs active layer.
منابع مشابه
Fabrication of three-dimensional autocloned photonic crystal on sapphire substrate.
We applied the laser interference lithography method to form a patterned sapphire substrate (PSS). A three-dimensional photonic crystal was formed by autocloning the PSS with alternate Ta2O5/SiO2 coatings. A high total integrated reflectance (TIR) band was obtained around the 410 to 470 nm wavelength range that matched the emission spectrum of the gallium nitride (GaN) light-emitting diode (LED...
متن کاملEnhancement of InGaN-Based Light Emitting Diodes Performance Grown on Cone-Shaped Pattern Sapphire Substrates
To enhance light extraction effciency, high-quality InGaN-based light emitting diodes (LED) was grown on cone-shaped patterned sapphire (CPSS) by using metal organic chemical vapor deposition (MOCVD). From the transmission electron microscopy (TEM) observation, the CPSS was confirmed to be an efficient way to reduce the threading dislocation density in the GaN epilayer. A sharp and high intensi...
متن کاملAbbreviated MOVPE nucleation of III-nitride light-emitting diodes on nano-patterned sapphire
Metalorganic vapor phase epitaxy (MOVPE) nucleation studies of GaN on planar sapphire and nanopatterned AGOG (Deposition of Aluminum, Growth of Oxide, and Grain growth) sapphire substrates were conducted. The use of abbreviated GaN growth mode, which utilizes a process of using 15 nm low-temperature GaN buffer and bypassing etch-back and recovery processes during epitaxy, enables the growth of ...
متن کاملDepth-resolved confocal micro-Raman spectroscopy for characterizing GaN-based light emitting diode structures.
In this work, we demonstrate that depth-resolved confocal micro-Raman spectroscopy can be used to characterize the active layer of GaN-based LEDs. By taking the depth compression effect due to refraction index mismatch into account, the axial profiles of Raman peak intensities from the GaN capping layer toward the sapphire substrate can correctly match the LED structural dimension and allow the...
متن کاملLight-Output Enhancement of GaN-Based Light-Emitting Diodes with Three-Dimensional Backside Reflectors Patterned by Microscale Cone Array
Three-dimensional (3D) backside reflector, compared with flat reflectors, can improve the probability of finding the escape cone for reflecting lights and thus enhance the light-extraction efficiency (LEE) for GaN-based light-emitting diode (LED) chips. A triangle-lattice of microscale SiO2 cone array followed by a 16-pair Ti3O5/SiO2 distributed Bragg reflector (16-DBR) was proposed to be attac...
متن کامل