Analysis of Pressure Transient Data from ' Lte Sumika
نویسندگان
چکیده
The permeability structure of the Sumikawa geothermal field in northern Japan has been the subject of an extensive pressure-transient testing investigation since 1986. In this paper, various pertinent data sets are presented and analyzed, including results showing reservoir heterogeneity (i.e. boundary) effects and apparent double porosity behavior. Interference tests between wells SB-3 and SD-2 (both of which have feedpoints in dacitic layers in the "marine-volcanic complex" formation) were carried out during 1990. The results have been interpreted to indicate the presence of a moderately high permeability (4 darcy-meters) layer with two impermeable boundaries intersecting at a right angle. The 1988 pressure buildup data for well SN-7D are also explained by assuming two impermeable boundaries in a high transmissivity reservoir within the deep "granodiorite" formation. Interference tests between wells S-4 and KY-1 have suggested that a very permeable north-south channel is present in the "altered andesite" layer. Although the response was successfully interpreted using an "anisotropic line-source model" by Garg et a1.(1991), a "double porosity channel model" seems to be particularly applicable for explaining both the short-term and long-term behavior observed in this series of tests.
منابع مشابه
Transient thermoelastic analysis of FGM rotating thick cylindrical pressure vessels under arbitrary boundary and initial conditions
Assuming arbitrary boundary and initial conditions, a transient thermo-elastic analysis of a rotating thick cylindrical pressure vessel made of functionally graded material (FGM) subjected to axisymmetric mechanical and transient thermal loads is presented. Time-dependent thermal and mechanical boundary conditions are assumed to act on the boundaries of the vessel. Material properties of the ve...
متن کاملTransient thermal study of recuperative tube in tube heat exchanger operating in refrigeration system using experimental test and mathematical simulation
Joule-Thomson cooling systems are used in refrigeration and liquefaction processes. There are extensive studies on Joule-Thomson cryogenic systems, but most of them coverage steady state conditions or lack from experimental data. In the present work, transient thermal behavior of Joule-Thomson cooling system including counter current helically coiled tube in tube heat exchanger, expansion valve...
متن کاملDetermination of Pore Pressure from Sonic Log: a Case Study on One of Iran Carbonate Reservoir Rocks
Pore pressureis defined as the pressure of the fluid inside the pore space of the formation, which is also known as the formation pressure. When the pore pressure is higher than hydrostatic pressure, it is referred to as overpressure. Knowledge of this pressure is essential for cost-effective drilling, safe well planning, and efficient reservoir modeling. The main objective of this study is to ...
متن کاملAnalysis of Transient Flow in the Case of Secondary Injection for Transient Vector Control (RESEARCH NOTE)
The purpose of this paper is to analyze the flow field structure in transient state and performance of secondary injection system for thrust vectoring in divergent section of a two-dimensional nozzle. Secondary injection for thrust vectoring in a two-dimensional nozzle is studied by solving three-dimensional Reynolds-averaged equations by means of fluent solver. Spalart-allmaras model was used ...
متن کاملA Least Squares Approach to Estimating the Average Reservoir Pressure
Least squares method (LSM) is an accurate and rapid method for solving some analytical and numerical problems. This method can be used to estimate the average reservoir pressure in well test analysis. In fact, it may be employed to estimate parameters such as permeability (k) and pore volume (Vp). Regarding this point, buildup, drawdown, late transient test data, modified Muskat method, interfe...
متن کامل