Effect of metal design and technique on the marginal characteristics of the collarless metal ceramic restoration.

نویسندگان

  • D M Belles
  • R J Cronin
  • E S Duke
چکیده

This investigation examined the marginal characteristics of the collarless metal ceramic restoration made with two commonly used direct-lift techniques: (1) a porcelain/wax paste and (2) a porcelain/liquid slurry. The metal copings touched the shoulder in half of the groups and were left 0.5 mm short in the other half to comprise the four experimental groups. Marginal seal was evaluated at facial and lingual surfaces on embedded and sectioned specimens for each group. Photo negatives were made of each specimen and projected at a constant magnification so that tracings could be made of the space between the die shoulder and corresponding porcelain. Composite surface measurements were made for each sample with a Zeiss Interactive Digital Analysis System instrument to evaluate porcelain adaptation to the shoulder. The porcelain/liquid groups demonstrated significantly smaller (p less than or equal to 0.05) facial marginal openings than the porcelain/wax groups. The group made with the porcelain/liquid technique with the metal on the die shoulder produced the most consistent overall results. The porcelain/liquid group with the metal off the shoulder had a statistically larger (p less than or equal to 0.05) mean marginal opening from the external margin to a point 0.75 mm to the interior than both techniques with the metal on the shoulder. Lingual marginal adaptation did not vary with each of the four experimental groups.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The evaluation and comparison of marginal adaptation in metal ceramic and all ceramic restorations fabricated by two methods: CAD/CAM and conventional

Introduction: Marginal fit is a key factor for long term clinical success through any dental restorations. Poor marginal adaptation causes cement dissolution. This can lead to dental caries, gingival irritation, periodontal diseases, and finally treatment failure. The aim of this study was measurement and comparison of marginal gap quantities in metal ceramic and all ceramic dental restorations...

متن کامل

Comparison of Marginal Fit between Collarless Metal Ceramic and two all Ceramic Restorations

Marginal adaptation of the crown is a crucial factor in determining its clinical acceptability. Crown fit as judged by marginal seal influences the longevity of the cast restorations to a great extent. Metal ceramic restorations have been implicated for the discoloration in area of labio-gingival margin. Attempts to rectify this, by altering the design of metal frame works as eliminating the la...

متن کامل

اثر کلار در تغییر شکل مارژین روکش های ساخته شده از آلیاژ بیس متال

It has been shown that noble alloys require metal collar to resist distortion when subjected to repeat firing cycle of porcelain. Metal collar is undesirable due to esthetic concerns. Since base metal alloys have superior physical properties, it seems that metal collar would not be necessary for obtaining better marginal adaptation of base metal crowns. The Purpose of this study was to evaluate...

متن کامل

Marginal Strength of Collarless Metal Ceramic Crown

Metal ceramic restorations have been implicated for the discoloration in area of labiogingivalmargin. Attempts to rectify this, by altering the design of metal frameworkswill lead to decrease in fracture strength atmargin. This in vitro study compared the fracture strength at margins of metal ceramic crowns cemented to metal tooth analogs. Crowns evaluated with different marginal configurations...

متن کامل

A study on the fracture strength of collarless metal-ceramic fixed partial dentures

PURPOSE The objective of this study was to evaluate fracture strength of collarless metal-ceramic FPDs according to their metal coping designs. MATERIALS AND METHODS Four different facial margin design groups were investigated. Group A was a coping with a thin facial metal collar, group B was a collarless coping with its facial metal to the shoulder, group C was a collarless coping with its f...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Journal of prosthetic dentistry

دوره 65 5  شماره 

صفحات  -

تاریخ انتشار 1991