Maximization of Received Signal Power by Impedance Matching in Human Body Communication Receiver
نویسندگان
چکیده
Human body communication (HBC) utilizes human body as part of the transmission channel. The present paper deals with HBC between a transmitter worn on the user’s wrist and an off-body stationary receiver touched by the user’s finger. In this configuration, transmitter-human-body system can be regarded as a signal source as viewed from the receiver. The equivalent output impedance of this signal source mainly consists of resistance of human body and capacitive reactance among the receiver, human body, and the surrounding environment. Impedance matching was achieved by inserting an inductor to cancel the capacitive reactance and adjusting the input resistor to match the resistance of the equivalent output impedance. At frequency of 10 MHz, maximum received power was obtained with 40 H inductor and 1.5 kinput resistance. This suggests that the output impedance of the transmitter-human-body system is 1500-j2500 .
منابع مشابه
A Study on the Optimal Receiver Impedance for SNR Maximization in Broadband PLC
We consider the design of the front-end receiver for broadband power line communications. We focus on the design of the input impedance that maximizes the signal-to-noise ratio (SNR) at the receiver. We show that the amplitude, rather than the power, of the received signal is important for communication purposes. Furthermore, we show that the receiver impedance impacts the amplitude of the nois...
متن کاملSNR Maximization at CSI Aware AF Relay
This paper concerns two-hop communication over relay-assisted Block fading channel. It is assumed there is not a direct link between the transmitter and the affiliated destination and the communication occurs in two hops through the use of a relay, where the amplify and forward (AF) strategy is employed at this node. In this case, in a Rayleigh block fading channel, the optimal weight function ...
متن کاملDesign Challenges and Performance Parameters of Low Noise Amplifier
Wireless communication system is an integral part of day today communication. For effective wireless communication, faithful transreceiption of the signal is required. It can be achieved by careful design of the receiver circuit. Hence there is wide scope of improvement in different blocks of the receiver. LNA is the first block of any receiver in communication system. At the receiver side in c...
متن کاملPower Allocation In Cooperative Relay Channels
This paper concerns power allocation in relay-assisted wireless channels for two-hop transmission. First, the transmitter sends the information to both the relay and receiver parts. Next, in the second hop, the transmitter cooperates with the relay to increase the received signal to noise ratio (SNR), assuming the relay makes use of the Amplify and Forward (AF) strategy. Moreover, it is assumed...
متن کاملSum-Rate Maximization Based on Power Constraints for Cooperative AF Relay Networks
In this paper, our objective is maximizing total sum-rate subject to power constraints on total relay transmit power or individual relay powers, for amplify-and-forward single-antenna relay-based wireless communication networks. We derive a closed-form solution for the total power constraint optimization problem and show that the individual relay power constraints optimization problem is a quad...
متن کامل