Width-controlled M-type hexagonal strontium ferrite (SrFe12O19) nanoribbons with high saturation magnetization and superior coercivity synthesized by electrospinning

نویسندگان

  • Panpan Jing
  • Jinlu Du
  • Jianbo Wang
  • Jinwu wei
  • Lining Pan
  • Jianan Li
  • Qingfang Liu
چکیده

Width-controlled M-type hexagonal SrFe12O19 nanoribbons were synthesized for the first time via polyvinylpyrrolidone (PVP) sol assisted electrospinning followed by heat treatment in air, and their chemical composition, microstructure and magnetic performance were investigated. Results demonstrated that as-obtained SrFe12O19 nanoribbons were well-crystallized with high purity. Each nanoribbon was self-assembled by abundant single-domain SrFe12O19 nanoparticles and was consecutive on structure and uniform on width. PVP in the spinning solution played a significant influence on the microstructure features of SrFe12O19 nanoribbons. With PVP concentration increasing, the ribbon-width was increased but the particle-size was reduced, which distributed on a same ribbon were more intensive, and then the ribbon-surface became flat. The room temperature magnetic performance investigation revealed that considerable large saturation magnetization (Ms) and coercivity (Hc) were obtained for all SrFe12O19 nanoribbons, and they increased with the ribbon-width broadening. The highest Ms of 67.9 emu · g(-1) and Hc of 7.31 kOe were concurrently acquired for SrFe12O19 nanoribbons with the maximum ribbon-width. Finally, the Stoner-Wohlfarth curling model was suggested to dominate the magnetization reverse of SrFe12O19 nanoribbons. It is deeply expected that this work is capable of opening up a new insights into the architectural design of 1D magnetic materials and their further utilization.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Simple Method for Synthesis of Strontium Ferrite Nanoparticles and their Polymeric Nanocomposites

Hard magnetic SrFe12O19 (SrM) nanoparticles were synthesized by a facile sonochemical reaction. The magnetic nanoparticles were then added to acrylonitrile-butadiene-styrene, polystyrene, polycarbonate, and poly sulfone to make magnetic nanocomposites. The magnetic properties of the samples were also investigated using an alternating gradient force magnetometer. The strontium ferrite nanop...

متن کامل

The Influence of Reaction Parameters on Magnetic Properties of Synthesized Strontium Ferrite

The conventional ceramic route was utilized to prepare a hard magnetic powder (M-type strontium ferrite, SrFe12O19). The stoichiometric mixture of iron oxide and strontium carbonate were calcined at 1000C and then fired at various temperatures. The influence of various reaction parameters such as mixing ratio, calcination temperature, firing temperature and firing time on the magnetic behaviors...

متن کامل

Strontium hexa-ferrites and polyaniline nanocomposite: Studies of magnetization, coercivity, morphology and microwave absorption

In this work, the investigation of wave absorption, phase formation, crystal structure and magnetic properties of SrFe12O19 hexa-ferrites nanoparticles that synthesized by co-precipitation using a microwave heating system and polyaniline-SrFe12O19 was carried out by using a combination of vector network analyser (VNA), X-ray diffraction (XRD), scanning electron microscopy (SEM), and Fourier tra...

متن کامل

Sonochemical assisted synthesis of SrFe12O19 nanoparticles.

We present the synthesis of M-type strontium hexaferrite by sonochemistry and annealing. The effects of the sonication time and thermal energy on the crystal structure and magnetic properties of the obtained powders are presented. Strontium hexagonal ferrite (SrFe12O19) was successfully prepared by the ultrasonic cavitation (sonochemistry) of a complexed polyol solution of metallic acetates and...

متن کامل

A novel method to fabricate CoFe2O4/SrFe12O19 composite ferrite nanofibers with enhanced exchange coupling effect

Nanocomposite of CoFe2O4/SrFe12O19 has been synthesized by the electrospinning and calcination process. A novel method that cobalt powder was used to replace traditional cobalt salt in the precursor sol-gel for electrospinning was proposed. The crystal structures, morphologies, and magnetic properties of these samples have been characterized in detail. Moreover, when the average crystallite siz...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 5  شماره 

صفحات  -

تاریخ انتشار 2015