Mathematical Modeling of Curve Sawing Techniques for the Lumber Industry
نویسنده
چکیده
Curve sawing is a technique used more and more widely in lumber mills in order to obtain more commercially valuable pieces from a given log. It is important to understand and know this technique in order for it to be used optimally. This article deals with the mathematical modeling of curve sawing, so that a module pertaining to curve sawing can be incorporated into the Optitek software, which simulates a lumber mill and its operations.
منابع مشابه
Development of a 3d Log Sawing Optimization System for Small Sawmills in Central Appalachia, Us
A 3D log sawing optimization system was developed to perform log generation, opening face determination, sawing simulation, and lumber grading using 3Dmodeling techniques. Heuristic and dynamic programming algorithms were used to determine opening face and grade sawing optimization. Positions and shapes of internal log defects were predicted using a model developed by the USDA Forest Service. L...
متن کاملThe frequency and level of sweep in mixed hardwood saw logs in the eastern United States
Hardwood sawmills traditionally saw logs in a manner that either orients sawlines parallel to the log central axis (straight sawing) or the log surface (allowing for taper). Sweep is characterized as uniform curvature along the entire length of a log. For logs with sweep, lumber yield losses from straight and taper sawing increase with increasing levels of sweep. Curve sawing logs with sweep wi...
متن کاملSimulation of Hardwood Log Sawing
Preface Abstract Mathematical modeling computer programs for several hardwood sawing systems have been developed and are described. One has judgment capabilities. Several of the subroutines are common to all of the models. These models are the basis for further research which examines the question of best-grade sawing method in terms of lumber value yield. This Research Paper is one in a series...
متن کاملEffect of Curve Sawing on Lumber Recovery and Warp of Short Cherry Logs Containing Sweep
—It has been estimated that approximately one-third of hardwood sawlogs have a significant amount of sweep and that 7 to nearly 40 percent of the yield is lost from logs that have greater than 1 inch of sweep. While decreased yield is important, for hardwood logs the loss of lumber value is likely more significant. A method that produced lumber while accounting for log curvature (sweep) would a...
متن کاملThe effect of curve sawing two-sided cants from small-diameter hardwood sawlogs on lumber and pallet part yields
Curve sawing is a primary log breakdown process that incorporates gang-saw technology to allow two-sided cants from logs with sweep to be cut parallel to the log surface or log axis. Since curve-sawn logs with sweep are cut along the grain, the potential for producing high quality straight-grain lumber and cants increases, and strength, stiffness, and dimensional stability are maximized. Presen...
متن کامل